The boiler display
Two boiler displays, “Good or Technical” see below.
Good
or standard read out.
During this reading the display will only show what is necessary. Under normal circumstances the display will give a Good reading. In case of a fault this will be shown with, alternate display of Good, with an E or BL code. See further "Errors, maintenance and warranty" .
Operating instructions Rinnai Q-Series
10
0
1
2
3
4
5
6
7
8
9
A
Technical
The second way is a technical read out. In normal situations the following will be shown:
•on the left the status in which the boiler is active
(see bottom of this page);
•on the right the supply temperature in °F;
•the water pressure in the installation in PSI.
When a message (E or BL code) is necessary this will be shown instead of the technical read out.
To switch over from the
- Press 5 sec. on the
Operation indication
(in the first display position by technical read out)
No heat demand
Fan pre/post purge
Ignition phase
Burner active on central heating
Burner active on DHW
Fan check
Burner off when room thermostat is demanding Pump overrun phase for central heating Pump overrun phase for hot water
Burner off because of to high flow temperature
Automatic