Stovax 7008, 7051Bl, 7053lG manual Commissioning, Give the copy of the Instructions to the customer

Page 22

COMMISSIONING

COMMISSIONING

1.1To commission:

•Replace the firebricks, baffle, and log retainer

•Check the door alignment and catch operation, adjust if required, see Installation Section 6. Adjusting Door hinges

•Check the soundness of door seals, castings and joints

•Check the operation of the air controls

1.2Now carry out a final smoke draw test:

•First warming the flue with a blowlamp, or similar, for about 10 minutes

•Place a smoke pellet on the centre of the grate, with the air controls open

•Close the door

Smoke should now be drawn up the flue and be seen to exit from the flue terminal

•Complete test with all doors and windows closed in the room where the appliance is fitted

•If there are any extractor fans in adjacent rooms, the test must be repeated with the fans running on maximum and interconnecting doors open

•Check the effect of ceiling fans during the test

If the test fails, re-check the suitability of the flue system and ventilation. An inadequate air supply to the room is potentially dangerous.

•Light the appliance and slowly increase the temperature to operating levels

•Ensure no combustion products enter the room

•Open the main fire door when the appliance reaches operating condition and carry out a spillage test with a smoke match or pellet around the door opening

1.3If excessive spillage occurs:

•Allow the appliance to cool and re-check the flue system and ventilation

1.7Finally:

•Explain the safe operation of the appliance and the use of the controls to the user and the importance of only using suitable fuels

•All open flued appliances can be affected by temporary atmospheric conditions which may allow fumes to enter the house. Because of this it is recommended that an electronic carbon monoxide detector conforming to BSEN50291 be fitted and maintained.

•Explain the cleaning and routine maintenance requirements

•Explain the requirement to use a suitable fireguard when children, elderly or infirm persons are near the appliance

•Record dealer/supplier details and installer details in Instructions

•Record serial number in page 3 of Instructions

This number is required when ordering spare parts and making warranty claims

•Give the copy of the Instructions to the customer

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Brunel 1A/2CB/3CB Installation Installation InstructionsPRE-INSTALLATION Commissioning Maintenance & ServicingDealer appliance was purchased from Appliance Commissioning ChecklistInstallation Engineer Essential Information Must be completedSerial Number User InstructionsGeneral Points AIR ControlsRecommended Fuels Using the Appliance for the First TimeUse a protective gloved hand to operate. See Diagram Do not touch the paint during the first period of useWood Lighting the fireSolid fuel PR7225aBurning Wood Running The applianceAir Inlets Log Guard AR2147 Close the door Burning Solid fuelBurning tips OVER-FIRING ASH RemovalOver night burning Chimney fireChimney Sweeping General CleaningCleaning Glass Care of stoveRiddling mechanism jamming Troubleshooting tipsSeasonal use Glass crackingBrunel TECHNICAL SPECIFICATIONStandard features Packing listPR7225 Brunel DimensionsAll dimensions in mm .4mm = ModelMax. Draught = 2.0mm Wg Min. Draught = 1.0mm Wg U.K Site RequirementsFlue or Chimney Flue PlateHearth Dimensions Flue Outlet PositionsWalls next to hearths 150mm Minimum Thickness W PR7227Flue PRE-INSTALLATION ChecksAdditional Ventilation Ventilation Top flue pipe installation Installation InstructionsInstalling the Appliance Legal requirementsDo not use a 90˚ elbow to make this connection Rear flue pipe installationRemoval of the LOG Guard Do not use appliance without the log guard in positionFitting and Removal Fitting & Removal of BaffleBrunel 1A only Riddling Mechanism Multi-fuel onlyCommissioning CommissioningGive the copy of the Instructions to the customer Annual Service Fitting a NEW Door Glass ALL Models Fitting and Removal of the FirebricksFitting and Removal of Baffle Fitting a new door sealBrunel 3CB Basic Spare Parts ListBrunel 1A Brunel 2CB Brunel 1APage Service Records Page
Top Page Image Contents