7.DC 12V Input Jack:
Connect the 12V DC plug from the AC/DC adapter.
8.Balanced Audio Output Jack: XLR type connector
9.Unbalanced Audio Output Jack: 1/4" Phone Jack
10.Unbalanced Level Switch:
“LOW selection is for
11.Squelch Adjustment:
Adjust the squelch level to eliminate the RF noise interference at the receiver.
2.INSTALLATION OF THE RECEIVER
1.Install one of the antennas at the antenna input connector A. Then install the other antenna at the antenna input connector B.
2.AC/DC Power Connection:
Figure 3
Connect the AC/DC adapter cable to the DC 12V input jack. Then plug the adapter unit into an appropriate AC outlet as shown in Figure 3. Caution: Make sure the correct voltage is present at the AC outlet as indicated on the AC/DC adapter.
5