Note: Read entire instruction sheet before you start installation and assembly.
WARNING
•Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call Peerless customer care at
•This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard- ware and components.
•Never exceed the Maximum UL Load Capacity. See page one.
•If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud finder is highly recommended.
•Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
•Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.
•This product was designed and intended to be mounted to the following supporting surfaces checked below with the hardware included in this product as specified in the installation sheet. To mount this product to an alternative support- ing surface, contact Peerless customer care at
•This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION | ADDITIONAL HARDWARE REQUIRED | |
x | Wood Stud | None |
x | Wood Beam | None |
x | Solid Concrete | None |
x | Cinder Block | None |
| Metal Stud | Do not attach except with Peerless accessory kit for metal studs; |
|
| Contact Customer Service for Peerless accessory kit for metal studs. |
| Brick | Contact Customer Service |
| Other or unsure? | Contact Customer Service |
Tools Needed for Assembly
•level
•phillips screwdriver
Table of Contents |
|
Parts List | 3, 4 |
Assembling Floor Stand | 4 |
Attaching Screen Using Universal Plate with Adapter Brackets | 8 |
Attaching Screen with VESA 100 Mounting Pattern | 11 |
2 of 11 | ISSUED: |