Installing Adapter Brackets
WARNING
•Tighten screws so adapter brackets are firmly attached. Do not tighten with excessive force. Overtightening can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
•If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly secured, damage may occur to screen or product may fail.
13 | To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place screen |
face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs, base, cover, or |
screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the adapter brackets to be attached. Select the small, medium, large or extra large screws from the baffled fastener pack then attach tilt brackets to screen following figure 13.1 or 13.2.
NOTE: Top and bottom mounting holes must be used for attaching brackets. Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
X
G
CENTER BRACKETS VERTICALLY
ON
BACK OF SCREEN
X
Notes:
•The number of fasteners used will vary, depending upon the type of screen.
•
•Use the corresponding hole in the multi- washer that matches your screw size as shown.
Note: "X" dimensions should be equal.
MEDIUMHOLEFORM5SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
NOTE: For flat back screens proceed to step
8 of 11 | ISSUED: |