KEY TO MAIN COMPONENTS OF THE APPLIANCE
1.Foldable handle
2.On/Off button on appliance
3.Release button for foldable handle
4.Release button for
5.
6.On/Off button on
7.Opening button
8.Lock tab
9.Filter (two parts)
10.Lock hole
11.Dust container
12.Nozzle tip
13.Extendable crevice nozzle
14.Motor section
15.Ventilation holes (on both sides of the appliance)
16.Recharging indicator
17.Charging socket on
18.Charger with cord
19.Connector on floor nozzle
20.Mounting screw
21.Floor nozzle
22.Rotating brush head
PREPARING THE APPLIANCE
For safety reasons, the battery is only partially charged when the appliance leaves the factory. Therefore, you must always start by charging the battery fully. Charge the appliance for at least 20 hours before first use.
Battery charging
1.Make sure the appliance is switched off.
2.Insert the charger (18) into the mains socket and connect the cord to the charger socket (17) on the
3.Switch on the power. The red recharging indicator (16) on the appliance lights up.
4.Leave the battery to fully charge
– approx. 20 hours, if the battery is completely discharged. The recharging indicator remains lit while the appliance is connected to the charger.
5.Switch off the power and remove the charger from the mains socket after recharging is completed.
NOTE:
•Immediately after use, the battery may be hot. Allow the battery to cool for approximately 30 minutes before charging in order to obtain the best result.
•The battery becomes hot during charging
– this is perfectly normal.
•The battery reaches its full capacity once it has been recharged
•Avoid discharging the battery completely. Take care to always recharge the battery after extended use of the appliance so that the appliance is always ready to be used again.
•Make sure the appliance is switched off on both on/off buttons (2 and 6) before charging.
USING THE APPLIANCE
This apparatus can be used both as a floor vacuum and as a
Before using the appliance, check that the filter (9) is correctly fitted in the dust container
(11)(see “Emptying of dust container and cleaning of filter”).
23