Preparing the Fan Site
Step 1 - Choose the Fan Site
Proper ceiling fan location and attachment to the building structure are essential for safety, reliable operation, maximum efficiency, and energy savings.
Choose a fan site where:
•No object can come in contact with the rotating fan blades during normal operation.
•he fan blades are at least 7 feet above the fl oor and the ceiling is at least 8 feet high.
•he fan blades have no obstructions to airflow, such as walls or posts, within 30 inches of the fan blade tips.
•he fan is directly below a joist or support brace that will hold the outlet box and the full weight of the fan.
30” From Wall or Nearest Obstruction
8’ Minimum Ceiling
7’ MinimumHeight Blades to
Floor
Checklist for Existing Fan Site
If you want to use an existing fan site, complete the following checklist to determine if the site is acceptable and safe for your new Hunter fan. If you cannot check off every item, prepare a new fan site as described on this page.
Fan Support System
•Fan attaches directly to building structure.
•Fan support system will hold full weight of the fan and light kit.
Ceiling Hole
•he outlet box clearance hole is directly below the joist or support brace.
Outlet Box
•he outlet box is an
•he outlet box is secured to the joist or support brace by wood screws and washers through the inner holes of outlet box.
•he outer holes of the outlet box are aligned with joist or support brace.
•he bottom of the outlet box is recessed a minimum of 1/16” into ceiling.
Wiring
•he electrical cable is secured to outlet box by an approved connector.
•Six inches of lead wires extend from outlet box.
If your existing fan site is suitable, skip ahead to Section 2 • Installing the
Ceiling Plate.
Suitable Existing Fan Site
Fan Support
System
Fan Support |
| Outlet Box |
| ||
System |
|
|
| Wiring |
3