HoMedics WFL-GDN instruction manual Assembly and Instructions for Use, Minimum Water Level

Assembly and Instructions for Use

1. Unpack the product. Wipe off dust with a damp cloth. (Fig 1)

Figure 1

Fountain Top

Figure 2

Attention:

In order to get best results, please operate pump completely submerged. Keep the water level above the minimum water level ALL THE TIME.

Minimum Water Level

Flow Control Valve

(+)faster water output

(-) slower water output

Rocks

Water	Tube	Platform
		Pump

Switch Base

Adaptor

Base Power Cord

2.Familiarize yourself with the pump. The switch located at the front of the pump controls the pump speed. The speed is indicated by a plus (+) and minus (-) sign. To increase the speed, move the switch slowly downward in the direction of the plus sign. You will hear a click as the switch moves to each speed level. At its highest speed level, the switch will cease to move any further. To decrease the pump speed, move the switch upward toward the minus sign. Similarly, at its lowest speed, the switch will cease to move any further (Fig 2).

NOTE: It is recommended the pump be set at its highest speed during assembly and later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed setting.

3.Insert the tube into the pump. (Fig. 3)

4.Set the fountain top onto the base aligning the straight edge of the platform with the straight edge of the inside of the base. (Fig. 4)

5.Fill base with clean water. Add enough water so that the platform is submerged. (Fig. 5) Figure 3

Tube

Pump

Figure 4

Figure 5

Platform

Line up straight edge

Water Level

4 5