Samsung HT-F9750W/EN, HT-F9750W/XN manual Subwoofer Surround Speaker L Centre Speaker, Speaker R

Subwoofer

Surround

Speaker (L)

Centre Speaker

Surround

Speaker (R)

							Front/Front Top	03
							Speaker (L)	Connections
	SPEAKERSOUT		CENTER		FRONT L	FRONT TOP L
			IMPEDANCE : 3Ÿ				Front/Front Top
		SUBWOOFER			FRONT R	FRONT TOP R	Speaker (R)
T
		OUT
L	ASC IN	SPEAKERS	CENTER	FRONT	FRONT TOP
			SUBWOOFER	FRONT	FRONT TOP
N			IMPEDANCE : 3Ÿ

Wireless Receiver Module

* This product should be connected with the SWA-6000 only.

CAUTION

If you want to install the product on the wall, fasten the screws or nails on the wall firmly and use the holes on the rear of speaker to install. However, when you install it, accessories (nails or screws) and installation is not provided by the company.

Do not let children play with or near the speakers. They could get hurt if a speaker falls.

When connecting the speaker wires to the speakers, make sure that the polarity (+/–) is correct.

Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien substances into the duct (hole) of the subwoofer speaker.

Do not hang the subwoofer on the wall using the duct (hole).

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture. For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.

If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II. In 2-CH mode, you will hear no sound from the wireless surround speakers.

NOTES

If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic field.

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, sound from the speakers may be disrupted because of interference.

If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment or any other device that uses the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference. The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.

If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless receiver module. With the product turned off, press "0""1""3""5" on the remote control. Turn on the wireless receiver module. Then, press and hold the “ID SET” button on the back of the wireless receiver module for 5 seconds, and then turn the product on.

English 17