Samsung HT-F9750W/TK, HT-F9750W/XN Networks and the Internet, Configuring your Network Connection

Settings

Networks and the Internet

When you connect this product to a network, you can use network based applications and functions such as Smart Hub and BD-LIVE, and upgrade the product's software through the network connection. For more information about accessing and using Internet services, see the Network Services chapter of this manual on pages 45~53. Instructions for configuring the network connection start below.

Configuring your Network Connection

If you didn't configure your network connection during the initial settings procedure or you need to reset the network connection, follow the directions below.

Before you begin, contact your Internet Service Provider to find out if your IP address is static or dynamic. If it

is dynamic, and you have a wired or wireless network, we recommend using the Automatic configuration procedures described below.

If you are connecting to a wired network, connect the product to your router using a LAN cable before you start the configuration procedure.

To begin configuring your network connection, follow these steps:

1.In the Home screen, select Settings, and then press the E button.

2.Select Network, and then press the E button.

3.Select Network Settings, and then press the E button.

4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks starting on page 27.

Wired Network

❑Wired – Automatic

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the E button. The product detects the wired connection, verifies the network connection and then connects to the network.

2.When it is done, highlight OK, and then press E button.

❑Wired - Manual

If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the E button.

The product searches for a network, and then displays the connection failed message.

NOTES

If it is possible to connect the home cinema to your network wirelessly, select Change Network at this point, change the Network type to Wireless, and then go to the instructions for wireless networks on page 27.

Network Settings

Wired network connection failed.	XX:XX:XX:XX:XX:XX
MAC Address
IP Address	0.	0.	0.	0
Subnet Mask	0.	0.	0.	0
Gateway	0.	0.	0.	0
DNS Server	0.	0.	0.	0

Unable to connect to the network. Try the following: check if your IP address is set correctly in IP Settings. Contact your Internet service provider for more information.

Change Network IP Settings Retry Close

2.Use the ◄► buttons to select IP Settings, and then press the E button. The IP Settings screen appears.

3.Select the IP setting field, and then set it to Enter manually.

4.Select a value to enter (IP Address, for example), and then press E. Use the number keypad on your remote control to enter the numbers for the value. You can also enter numbers using the ▲▼ buttons. Use the ◄► buttons on the remote control to move from entry field to entry field within a value. When done with one value, press the E button.

5.Press the ▲ or ▼ button to move to another value, and then enter the numbers for that value following the instructions in Step 4.

6.Repeat Steps 4 and 5 until you have filled in all values.

26 English