![](/images/new-backgrounds/1243323/24332319x1.webp)
![](/images/new-backgrounds/1243323/24332319xi2.webp)
Setting the Speaker
Before moving or installing the product, be sure to turn off the power and disconnect the power cord.Signal outputs and frequency response from the speaker will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.
√
REMOTE CONTROL
1 Press SPK SEL. button to select the speaker you want.
• Each time you press this button, F.SPK ➝ C.SPK ➝ S.SPK ➝ SB SPK ➝ SW SPK ➝ CROVR ➝ SPK MODE OFF will be selected in turn.
2 Press …† button to set the speaker as you want.
3
To Exit Setup Mode
•Wait for about 5 seconds or press the SPK SEL. button of the remote control to select SPK MODE OFF.
MAIN UNIT
1 Press and hold SURROUND button for about 5 seconds.
• “SETUP MODE” appears on the display and enters into Setup Mode.
2 Press INPUT button one time. | OPERATION |
SPK ➝SW SPK ➝ CROVR will be selected in turn. | |
• “SPEAKER SETUP” appears in the display. |
|
3 Press SURROUND button to select the speaker you want. |
|
Each time you press this button, F.SPK ➝ C.SPK ➝ S.SPK ➝ SB |
|
4 Press SELECT ( , ) button to set the speaker as you want. |
|
5 Repeat the steps 3 and 4 to set the speaker. |
|
To Exit Setup Mode
•Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit. “SETUP MODE OFF” appears on the display and exits Setup Mode.
To Use SUBWOOFER button of Remote Control
Press SUBWOOFER button.
•Each time you press this button, SW SPK : YES, SW SPK : NO will be selected in turn.
•If you play in 2 Channel Stereo, select 'YES' to use Subwoofer and 'NO' not to use.
Caution!
•If F.SPK is set to ‘SMALL’, SW SPK is fixed to ‘YES’.
•If S.SPK is set to ‘NONE’, SB SPK is fixed to ‘NONE’.
•You cannot use Speaker Setup Mode in 5.1CH MULTI CH function.
SettingtheSpeaker
•F.SPK (Front) : LARGE, SMALL
•C.SPK (Center) : LARGE, SMALL, NONE
•S.SPK (Rear) : LARGE, SMALL, NONE
•SB SPK (Rear Center) : LARGE, SMALL, NONE
•SW SPK (Subwoofer) : YES, NO
•CROVR (Crossover Frequency): 40, 60, 80, 100, 120, 150,200Hz
•LARGE : Select when you use large speaker. You can listen to full ranges of sound from bass to treble.
•SMALL : Select this when you use small speaker. Bass below 100ß‘ will not be output from the whole speakers but only from subwoofer.
•NONE : Select this when you use no speaker.
•YES : Select this when you use Subwoofer Speaker if you play back in 2 Channel Stereo.
•NO : Select when you do not use Subwoofer Speaker if you play back in 2 Channel Stereo.
•CROVR: Select the crossover frequency depending on the size of speaker connected when you use subwoofer. Select 40Hz if cone paper speaker is 16cm, select 60Hz for 14cm, 80Hz for 12cm, 100Hz for 10cm, 12Hz for 8cm ,150Hz for 6cm and 200Hz for 4cm.
17 | 18 |