Samsung DVD-HD850/XEL manual Troubleshooting, Problem Action, ENG-60

DVDHD850 XEL-00_Eng2 23/02/2005 15:38 Page 60

R E F E R E N C E

Troubleshooting

Before requesting service (troubleshooting), please check the following.

Problem		Action	Page
No operations can be	•	Check the batteries in the remote control.
performed with the		They may need replacing.
remote control.	•	Operate the remote control at a distance of no more than 20 feet.
	•	Remove batteries and hold down one or more buttons for several minutes to	P4
		drain the microprocessor inside the remote control to reset it. Reinstall
		batteries and try to operate the remote control again.
Disc does not play.	•	Ensure that the disc is installed with the label side facing up.	P7
	•	Check the region number of the DVD.
5.1 channel sound is	•	5.1 channel sound is reproduced only when the following conditions are met. :
not being reproduced.		1) The DVD player is connected with the proper Amplifier	P18
		2) The disc is recorded with 5.1 channel sound.
	•	Check whether the disc being played has the “5.1 ch” mark on the outside.
	•	Check if your audio system is connected and working properly.	P50~51
	•	In a SETUP Menu, is the Audio Output set to Bitstream?

The	icon appears	• The features or action cannot be completed at this time because:
on screen.		1. The DVD’s software restricts it.

2.The DVD’s software doesn’t support the feature (e.g., angles).

3.The feature is not available at the moment.

4.You’ve requested a title or chapter number or search time that is out of range.

Disc Menu doesn’t appear.	•	Check if the disc has a Menu.
Play mode differs from	•	Some of the functions selected in the Setup Menu may not work properly if the		P44~57
the Setup Menu		disc is not encoded with the corresponding function.
selection.
The screen ratio	•	The Screen Ratio is fixed on your DVDs.		P52~53
cannot be changed.
No audio.	•	Make sure you have selected the correct Digital Output in the Audio Options		P50~51
		Menu.
The screen is blocked	•	Press the	button for more than 5 seconds under no disc inside. All settings	P19
		will revert to the factory settings.
Forgot password	•	Press the	button for more than 5 seconds under no disc inside.
		All settings including the password will revert to the factory settings. Don't use		P55~57
		this unless absolutely necessary.
If you experience other	•	Go to the contents and find the section of the instruction book that contains
problems.		the explanations regarding the current problem, and follow the procedure once
		again.
	•	If the problem still cannot be solved, please contact your nearest authorized
		service center.
The picture is noisy or	•	Make sure that the disc is not dirty or scratched.		P2
distorted	•	Clean the disc.

R E F E R E N C E

Problem		Action	Page
No HDMI output.	•	Check the Video output is HDMI enabled.
	•	Check the connection between the TV and the HDMI jack of DVD player.	P15~16
	•	See if the TV supports this 576p/720p/768p/1080i DVD player.
Abnormal HDMI output	•	If snow noise appears on the screen, it means that TV does not support	P15~16
screen.		HDCP (High-bandwidth Digital Content Protection).
HDMI output Jitter	•	Check your TV system setup correctly.
	•	The screen Jitter phenomenon may occur when frame rate is converted from
		50Hz to 60Hz for 720P/1080i HDMI (High Definition Multimedia Interface)	P52~54
		Output.
	•	Please refer to the user’s manual of your TV.

Reference

ENG-60 ENG-61