Samsung HT-J5550W/XE, HT-J5500/EN, HT-J5550W/EN Network Setup, Configuring Your Network Connection

Settings

To show the RDS signals

You can see the RDS signals the station sends on the display.

Press the RDS DISPLAY button while listening to an FM station.

~Each time you press the button, the display change to show you the following information : PS NAME  RT  CT  Frequency

	While searching, <PS NAME>
PS (Program	appears and then the station
	names will be displayed.
Service)	<NO PS> appears if no signal is
	sent.
	While searching, <RT> appears
RT (RadioText)	and then text messages the
	station sends will be displayed.
	<NO RT> appears if no signal is
	sent.
Frequency	Station frequency (non-RDS
	service)

-When pressing the buttons on the primary remote control, make sure that you have selected the FM station using the primary remote control.

+

RDS DISPLAY		TA
1	2	3
PTY -	PTY SEARCH	PTY +
4	5	6

1.Press the PTY SEARCH button while listening to an FM station.

2.Press the PTY- or PTY+ button until the PTY code you want appears on the display.

~The display gives you the PTY codes described to the right.

3.Press the PTY SEARCH button again, while the PTY code selected in the previous step is still on the display.

~The centre unit searches 15 preset FM stations, stops when it finds the one you have selected, and tunes in that station.

About characters shown in the display

When the display shows PS,or RT signals,the following characters are used.

~The display window cannot differentiate upper case and lower case letters and always uses upper case letters.

~The display window cannot show accented letters, <A,> for instance, may stands for accented <A’s> like <À, Â, Ä, Á, Å and Ã.>

PTY (Program Type) indication and

PTY-SEARCH function

One of the advantages of the RDS service is that you can locate a particular kind of program from the preset channels by specifying the PTY codes.

To search for a program using the PTY codes

~Before you start!

-The PTY Search is only applicable to preset stations.

-To stop searching any time during the process, press 5 button while searching.

-There is a time limit in doing the following steps. If the setting is cancelled before you finish, start from step 1 again.

Network Setup

When you connect this product to a network, you can use network based applications and functions such as BD-LIVE and upgrade the product's software through the network connection.

Configuring Your Network Connection

To begin configuring your network connection, follow these steps:

1.In the Home screen, select Settings, and then press the E button.

2.Select Network, and then press the E button.

3.Select Network Settings, and then press the E button.

4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks on the right of next page.

22 - English