Samsung SPL300WX/XY, SPL300WX/EN, SPL300WVX/EN, SPL300WVX/XT manual Type 1 Model Code SPL300WX

Contains Mercury, Dispose According to Local, State or Federal Laws

Lamp Replacement Procedure

Since the lamp is a high temperature and high voltage product, wait at least one hour from the time that the power cord is disconnected before replacing it.

The lamp is located on the left side of the projector (when looking from the front).

Since the lamp type varies depending on the model code of a purchased product, make sure to check the model code when buying a lamp.

When replacing the lamp, check the model code of a purchased product first and refer to the appropriate replacement instructions.

The model code can be found on the label that is attached to the bottom or rear of the package box or product.

Type 1 (Model Code : SPL300WX/**)

Type 2 (Model Code : SPL300WVX/**)

Assembling a new lamp is in the reverse order of the disassembly.

Replacing and Cleaning the Filter

Precautions when replacing the projector filter

The filter is located at the bottom of the projector.

Turn off the power of the projector, and then disconnect the power cord after the heat of the projector is cooled sufficiently.

Otherwise, its parts may be damaged due to internal heat. When replacing the filter, dust may occur.

For inquiries on filter purchase, please refer to 'Contact SAMSUNG WORLDWIDE'.

The sequence for replacing or cleaning the filter of the projector.