Troubleshooting
A:Check the polarities
A:Check if the batteries are empty.
A:Check if the power is on.
A:Check if the power cord is securely connected.
A:Check if a special fluorescent or neon lamp is on in the vicinity.
Problems related to MagicInfo
Note
Making a Bootable USB Flash Disk.
Q:Making a Bootable USB Flash Disk
A:1) You can turn a common
A:2) Copies the OS ghost image and executables to your USB disk.
A:3) Enter the BIOS menu of your set by pressing the F2 key in the BIOS logo screen. Then, enable the USB Boot First option by selecting that option and pressing the Enter key in the Boot menu.
A:4) Switch your set on while your USB disk is connected and boot up in DOS mode.
A:5) Run C:\ghost.exe and choose Local → Partition → From Image from the menu. Choose the ghost image to update your USB disk with and choose the target disk.
A:6) When the ghost image update finishes, the set will be rebooted automatically.
Q & A
Q:How can I change the frequency?
A:The frequency can be changed by reconfiguring the video card.
Note
That video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)
Q:How can I clean the outer case/LCD Panel?
A:Disconnect the power cord and then clean the LCD Display with a soft cloth, using either a cleaning solution or plain water.
Do not leave any detergent or scratches on the case. Do not let any water enter the LCD Display.
Q:How can I play the video?
A:The video supports the MPEG1 and WMV codecs only. Install the corresponding codec to play the video. Note that some of the codecs can be incompatible.