Samsung LF00FNXPFBZXCI, LF-NXN2N/EN manual Networked standby mode, 2016, NTW Port Min Ethernet

1. Networked standby mode

1.1Test result where all NTW wired ports are connected and all NTW wireless ports activated ( This value could exceed requirement limit )

Test date

2016 .1.5

Power Consumption (W)

(rounded to the 1st decimal place)

1.3

1.2 The number and type of network ports ( it shall be declared if the same physical network port accommodates two or more types of network ports )

Logical Ports: 1 x Ethernet (100BaseT) (Position : Rear side of equipment)

Physical Ports: 1 x Ethernet

1.3Test result and information for each type of network port:

(a)The ( maximum ) power consumption

(b)The default time after which the power management function, or a similar function, switches the equipment into a condition providing networked standby

(c)The trigger that is used to reactivate the equipment

(d)The ( maximum ) performance specifications

(e)The communication protocol used by the equipment

NTW Port	(a), W	(b), min		(c)	(d)		(e)
Ethernet	1.6	N/A	IP traffic / ICMP ping		100 Mbps	Ethernet protocol
-	-	-		-	-		-
-	-	-		-	-		-
-	-	-		-	-		-
-	-	-		-	-		-
1.3 Test parameters
parameters		Actual	Limit	parameters		Actual	Limit
Ambient temperature (℃)		26.0	23±5	Test voltage (V)		230	230±2.3
Test frequency (Hz)		50	50±0.5	Total harmonic	distortion	1.42	2
				(%)
Crest factor		1.40	1.34~1.49	-		-	-

1.5Whether all network ports are deactivated before delivery Not all network ports are deactivated before delivery

1.6Whether the equipment qualifies as HiNA equipment or equipment with HiNA functionality ( where no information is provided, this is considered not to be the case )

N/A

1.7Instrumentation

Test instruments which were used in the test are as follows;

2