DEFAULT SETUP
To configure the video settings
You can set the video resolution and quality, and select the codec required.
1.Select <Basic> - <Video>.
The Video setup screen appears. y Brightness : Adjust the screen brightness from 1 to 100.
y Contrast : Adjust the contrast from 1 to 100.
yResolution : Set the video size of the MPEG4, H.264, and MPEG fi les.
-NTSC : 4CIF(704x480), VGA(640X480), CIF(352X240)
-PAL : 4CIF(704x576), VGA(640X480), CIF(352X288)
yQuality : Adjust the picture quality from 1 to 10.
yFrame rate : Select one from 30 fps, 15 fps, 8 fps, 3 fps, and 1 fps.
yBitrate control* : Select CBR (Constant Bit Rate) or VBR (Variable Bit Rate) for the compression method.
If selecting VBR, you can not set the target bit rate.
yTarget bitrate : Transfers video signal at a specifi ed bit rate.
yCompression : Adjust the compression rate from 5 through 100 by 5.
yEncode priority : Set the video
transfer method to Frame rate or Quality.
yGOP* size : Select a GOP size between 5 and 15.
yDeblock : This will soften the edges between macro blocks.
y
This can be set only if the resolution of MPEG4 video is 4CIF.
yProfile : Select Baseline or Main for the H.264 profiling method.
yEntropy coding* : Reduces the compression loss due to encoding.
yMotion estimation : Estimates the movement of pixels by determining the motion vector.
J If you set the profile to Baseline, the entropy coding is available only for CAVLC*; if you set it to MAIN, the entropy coding is available for both CAVLC* and CABAC*.
If you set WDR to <OFF>, or the resolution of MPEG4 video is other than 4CIF,
2.When done, click [Apply]. Your settings will be saved.
● SETUP SCREEN