Samsung AQV09PWCNEUR, AQV12PWAX, AQV09PWCXEUR, AQV12PWCXEUR, AQV12PWCNEUR manual Troubleshooting

Page 20

Troubleshooting

Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses.

PROBLEM

SOLUTION

 

 

 

The air conditioner does

• Check power status and then operate the air conditioner again.

not work at all.

• Plug in or switch on the circuit breaker and then operate the air conditioner again.

 

• Check if you have set the Off Timer. Operate the air conditioner again by pressing the

 

 

Power button.

 

 

 

The temperature

• Check if you have selected Fan/Turbo mode. In these modes, desired temperature is set to

adjustment is not working.

 

auto and you cannot adjust the temperature.

 

 

 

Cool/Warm air does

• Check if the set temperature is higher(during Cool mode)/lower(during Heat mode) than

not come out of the air

 

the current temperature. Press the Temp + or - button on the remote controller to change

conditioner.

 

the set temperature.

 

 

• Check if the Air filter is blocked by dirt. If there is a lot of dust on the Air filter,

 

 

cooling(heating) performance may decrease. Clean them frequently.

 

• Check if the outdoor unit is covered or installed near the obstacle. Take the cover off and

 

 

take the obstacle away.

 

 

• If you want to operate the air conditioner in the sunlight, cover the outdoor unit using

 

 

curtains or etc.

 

 

• Check if the air conditioner is operating in De-ice mode. When the ice formed in winter

 

 

or the outdoor temperature is too low, the air conditioner operates in De-ice mode

 

 

automatically. In De-ice mode, indoor fan stops and cool air does not come out.

 

• If the doors or windows are open, it may cause bad cooling (heating) performance.

 

 

Close the doors and windows.

 

 

• Check if the air conditioner has just been turned on after stopping cooling(heating)

 

 

operation. In this case, just a fan will run to protect the outdoor unit compressor.

 

• Check if the pipe length is too long. When the pipe length exceeds maximum allowable

 

 

pipe length, cooling (heating) performance may decrease.

 

 

 

 

Air flow adjustment is not

•

Check if you have selected Auto/Dry/

mode. In these modes, desired

working.

 

temperature is set to auto and you cannot adjust the temperature.

 

 

 

 

Fan speed adjustment is

•

Check if you have selected Auto/Dry/Turbo/

mode. In these mode, fan speed

not working.

 

is set to Auto and you cannot adjust the fan speed.

 

 

 

Remote controller is not

• Check if your batteries are depleted.

 

working.

• Make sure nothing is blocking your remote controller sensor.

•Check that there are strong lighting apparatus near the air conditioner. Strong light which comes from fluorescent bulbs or neon signs may interrupt the electric waves.

Timer function does not

• Check if you press the Set button on the remote controller after you have set the time.

set.

 

 

 

 

 

 

 

The indicator is blinking

• Press the Power

 

button or disconnect the power plug/switch off the auxiliary power

 

 

continuously.

switch.

 

If the indicator is still blinking, contact the service center.

 

 

 

 

Odors permeate in the

• Check if the appliance is running in a smoky area. Ventilate the room or operate the air

room during operation.

conditioner in Fan mode for 1~2 hours. (We do not use smelly components in the air

 

conditioner.)

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Page Contents Safety precautions Important safety symbols and precautionsFollow directions Wall socketFor Using For Cleaning Checking before use Operation rangesPower button Checking the name of the partsMain parts DisplayChecking the remote controller Remote controller buttonsRemote controller display Battery changing timeStoring the remote controller Inserting the batteriesBasic function Button to adjust the temperature PressAdjusting the air flow direction Using the Turbo functionPress the Air swing button on the remote controller Vertical air flowWhen the air conditioner is on and in cool/heat mode Press the button on the remote controllerMode Press the Time Up or Time Down button to set the timeAdditional options available in On timer mode Setting the On/Off timerPress the On Timer/Off Timer button Using the Smart Saver function From the moment you have set the timerIf the air conditioner is on If the air conditioner is off Turn off automaticallyWhen the air conditioner is turned on Using the Quiet functionUsing the Auto Clean function Cleaning the air conditioner Cleaning the indoor unitCleaning the outdoor unit heat exchanger Opening the panelCleaning the air filter Removing the Air filterOpen the panel and put the Air filter out Dry the Air filter in a ventilated areaMaintaining the air conditioner Periodical checksTroubleshooting Connection Outdoor unit Heat exchanger during Heat mode in winterFlow movement changes. It is normal AQV09P, AQV12P, AQV18P, AQV24P General informationIncluded Models Remark Choosing the installation location Installing the unitPower supply line, fuse or circuit breaker  a place where the air filter can be replaced easilyWhere sulfide gas exists Outdoor UnitWhen installing 1 outdoor unit When installing more than 1 outdoor unitSpace Requirements for Outdoor Unit Top view Side viewAccessories in the outdoor unit case AccessoriesAccessories in the indoor unit case Fixing the installation plate Optional accessoriesTools required for installation General Tools Tools for test operationsConnecting the cable Connecting the assembly cableCable specification Each wire is labeled with the corresponding terminal number InstallationPass the pipe through the hole in the wall Smooth the cut edgesCut off the remaining foam insulation Purging the indoor unit Cutting or extending the pipeUnscrew the caps at the end of each pipe Put a flare nut slightly into the pipe and modify the flarePipe 50 Pa. The joint must be accessible and serviceable Correct InclinedCracked Outer DiameterDrain hose installation Ensure that condensation draining is adequate Purging the connected pipesConnect a drain hose to the drain plug Adding Refrigerant 1975 Please fill in with indelible ink the factory refrigerant charge of the product Performing the gas leak tests To check for gas leaks on the outdoor unitTo check for gas leaks on the indoor unit Leak test with nitrogen before opening valvesFixing the outdoor unit in place Then place the indoor unit on the installation plateFixing the indoor unit in place Final Check and Trial Operation How to connect your extended power cables Apply heat to the contraction tube to contract itAfter tube contraction work is completed, wrap it with Insulation tape to finishPage 42 27 Samsung 7267864, € 0.07/min02-201-24-18 05 133Air Conditioner
Related manuals
Manual 41 pages 49.75 Kb Manual 21 pages 29.77 Kb Manual 41 pages 50.29 Kb Manual 43 pages 23.26 Kb Manual 41 pages 10.61 Kb Manual 39 pages 33.67 Kb Manual 43 pages 50.37 Kb Manual 41 pages 25.73 Kb Manual 41 pages 6.72 Kb Manual 41 pages 27.43 Kb Manual 43 pages 2.11 Kb Manual 41 pages 20.41 Kb

AQV09PSCXEUR, AQV09PWCNEUR, AQV09PWCXEUR, AQV12PWAX, AQV09PSCNEUR specifications

The Samsung AQV12PSCXEUR, AQV12PSCNEUR, AQV09PSCNEUR, and AQV09PSCXEUR are advanced air conditioning models that exemplify Samsung's commitment to energy efficiency and innovative cooling technology. These units are designed for both residential and commercial applications, providing optimal comfort and superior performance in diverse environments.

One of the main features of these models is their inverter technology, which allows for precise control over the cooling output. By adjusting the compressor's speed according to the current temperature, these air conditioners maintain a consistent climate, significantly reducing energy consumption compared to traditional units. This technology not only contributes to lower electricity bills but also enhances the system's lifespan by reducing wear and tear.

Additionally, these units are equipped with a high-performance air filtration system. This system captures dust, allergens, and other particulate matter from the air, ensuring a healthier indoor environment. The filters are designed to be easily removable and washable, promoting convenient maintenance and long-term efficiency.

The design and aesthetics of the Samsung AQV series are another highlight. With a sleek, modern appearance, these air conditioners can seamlessly blend into any room decor. The compact size offers flexibility in installation, allowing users to maximize space without compromising on style.

Noise levels are kept to a minimum thanks to the advanced engineering of these models. Utilizing sound-dampening technology, the AQV series operates quietly, making them suitable for bedrooms, offices, and other noise-sensitive areas.

Another key characteristic of the AQV12PSCXEUR, AQV12PSCNEUR, AQV09PSCNEUR, and AQV09PSCXEUR is their eco-friendly refrigerant. By utilizing R32 refrigerant, these models comply with environmental regulations and contribute to reduced greenhouse gas emissions. This is a significant advantage for environmentally conscious consumers looking to make sustainable choices.

In terms of user experience, these air conditioners feature a user-friendly interface and remote control functionality. This allows users to effortlessly adjust settings, program timers, and switch modes from the comfort of their seat. Additionally, many units in the series can be connected to smart home systems, providing even greater convenience through integration with mobile devices.

In conclusion, the Samsung AQV12PSCXEUR, AQV12PSCNEUR, AQV09PSCNEUR, and AQV09PSCXEUR air conditioners are packed with features designed for efficiency, comfort, and convenience. With their inverter technology, superior filtration systems, quiet operation, modern design, and eco-friendly refrigerants, they stand out as a leading choice for anyone seeking reliable cooling solutions.
Top Page Image Contents