Samsung AQV09PWCNEUR, AQV12PWAX Fixing the indoor unit in place, Fixing the outdoor unit in place

Page 38

Fixing the indoor unit in place

Perform the following work on the area where gas leak test was done priorly.

After checking for gas leaks in the system, insulate the pipe, hose and cables.

Insulation

Then place the indoor unit on the installation plate.

 

1. To avoid condensation problems, wrap foam insulation (as shown in the figure) on a part without insulation on the end of the pipes.

Pipes

2.Wind the pipe, assembly cable and drain hose with vinyl tape.

3.Place the bundle (the pipe, assembly cable and drain hose) in the lower part of the indoor unit carefully so it does not project from the rear of the indoor unit.

4.Hook the indoor unit to the installation plate and move the unit to the right and left until it is securely in place.

Installation

 

plate

Connecting

Vinyl tape

pipes

Connecting wires

 

Drain hose

 

• Make sure pipe does not move when you install the indoor unit on an installation plate.

5.Wrap the rest of the pipe with vinyl tape.

6.Attach the pipe to the wall using clamps (optional).

Fixing the outdoor unit in place

Install the outdoor unit in level on a stable base to avoid the generation of noise and vibration, especially when installing the unit close to a neighbor.

If you install the outdoor unit in a place exposed to strong winds or at a height, fix it to an appropriate support (wall or ground).

'X' mm

'Y' mm

1.Place the outdoor unit as indicated on the top of the unit to let the discharged air out properly.

2.Fix the outdoor unit in level to an appropriate support using anchor bolts.

3.If the outdoor unit is exposed to strong winds, install shield plates around the outdoor unit so that the fan can operate correctly.

• Secure the rubber leg to prevent the generation of noise and vibration.

Rubber leg

Model

X

Y

09/12PC

538

290

09/12PB

612

317

18

 

 

24

660

340

Outdoor unit installed on the wall by rack

•Ensure the wall will be able to suspend the weight of rack and outdoor unit;

•Install the rack close to the column as much as possible;

•Install proper grommet in order to reduce noise and residual vibration transferred by outdoor unit towards wall.

Designed to cut off residual vibration from outdoor unit to rack.

(not supplied with product)

Soft rubber designed to cut off vibration from rack to wall. (not supplied with product)

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Page Contents Follow directions Safety precautionsImportant safety symbols and precautions Wall socketFor Using For Cleaning Checking before use Operation rangesMain parts Power buttonChecking the name of the parts DisplayChecking the remote controller Remote controller buttonsStoring the remote controller Remote controller displayBattery changing time Inserting the batteriesBasic function Button to adjust the temperature PressPress the Air swing button on the remote controller Adjusting the air flow directionUsing the Turbo function Vertical air flowMode When the air conditioner is on and in cool/heat modePress the button on the remote controller Press the Time Up or Time Down button to set the timeAdditional options available in On timer mode Setting the On/Off timerPress the On Timer/Off Timer button If the air conditioner is on If the air conditioner is off Using the Smart Saver functionFrom the moment you have set the timer Turn off automaticallyWhen the air conditioner is turned on Using the Quiet functionUsing the Auto Clean function Cleaning the outdoor unit heat exchanger Cleaning the air conditionerCleaning the indoor unit Opening the panelOpen the panel and put the Air filter out Cleaning the air filterRemoving the Air filter Dry the Air filter in a ventilated areaMaintaining the air conditioner Periodical checksTroubleshooting Connection Outdoor unit Heat exchanger during Heat mode in winterFlow movement changes. It is normal AQV09P, AQV12P, AQV18P, AQV24P General informationIncluded Models Remark Power supply line, fuse or circuit breaker Choosing the installation locationInstalling the unit  a place where the air filter can be replaced easilyWhere sulfide gas exists Outdoor UnitSpace Requirements for Outdoor Unit When installing 1 outdoor unitWhen installing more than 1 outdoor unit Top view Side viewAccessories in the outdoor unit case AccessoriesAccessories in the indoor unit case Tools required for installation General Tools Fixing the installation plateOptional accessories Tools for test operationsConnecting the cable Connecting the assembly cableCable specification Each wire is labeled with the corresponding terminal number InstallationPass the pipe through the hole in the wall Smooth the cut edgesCut off the remaining foam insulation Unscrew the caps at the end of each pipe Purging the indoor unitCutting or extending the pipe Put a flare nut slightly into the pipe and modify the flareCracked Pipe 50 Pa. The joint must be accessible and serviceableCorrect Inclined Outer DiameterDrain hose installation Ensure that condensation draining is adequate Purging the connected pipesConnect a drain hose to the drain plug Adding Refrigerant 1975 Please fill in with indelible ink the factory refrigerant charge of the product To check for gas leaks on the indoor unit Performing the gas leak testsTo check for gas leaks on the outdoor unit Leak test with nitrogen before opening valvesFixing the outdoor unit in place Then place the indoor unit on the installation plateFixing the indoor unit in place Final Check and Trial Operation After tube contraction work is completed, wrap it with How to connect your extended power cablesApply heat to the contraction tube to contract it Insulation tape to finishPage 02-201-24-18 42 27Samsung 7267864, € 0.07/min 05 133Air Conditioner
Related manuals
Manual 41 pages 49.75 Kb Manual 21 pages 29.77 Kb Manual 41 pages 50.29 Kb Manual 43 pages 23.26 Kb Manual 41 pages 10.61 Kb Manual 39 pages 33.67 Kb Manual 43 pages 50.37 Kb Manual 41 pages 25.73 Kb Manual 41 pages 6.72 Kb Manual 41 pages 27.43 Kb Manual 43 pages 2.11 Kb Manual 41 pages 20.41 Kb

AQV09PSCXEUR, AQV09PWCNEUR, AQV09PWCXEUR, AQV12PWAX, AQV09PSCNEUR specifications

The Samsung AQV12PSCXEUR, AQV12PSCNEUR, AQV09PSCNEUR, and AQV09PSCXEUR are advanced air conditioning models that exemplify Samsung's commitment to energy efficiency and innovative cooling technology. These units are designed for both residential and commercial applications, providing optimal comfort and superior performance in diverse environments.

One of the main features of these models is their inverter technology, which allows for precise control over the cooling output. By adjusting the compressor's speed according to the current temperature, these air conditioners maintain a consistent climate, significantly reducing energy consumption compared to traditional units. This technology not only contributes to lower electricity bills but also enhances the system's lifespan by reducing wear and tear.

Additionally, these units are equipped with a high-performance air filtration system. This system captures dust, allergens, and other particulate matter from the air, ensuring a healthier indoor environment. The filters are designed to be easily removable and washable, promoting convenient maintenance and long-term efficiency.

The design and aesthetics of the Samsung AQV series are another highlight. With a sleek, modern appearance, these air conditioners can seamlessly blend into any room decor. The compact size offers flexibility in installation, allowing users to maximize space without compromising on style.

Noise levels are kept to a minimum thanks to the advanced engineering of these models. Utilizing sound-dampening technology, the AQV series operates quietly, making them suitable for bedrooms, offices, and other noise-sensitive areas.

Another key characteristic of the AQV12PSCXEUR, AQV12PSCNEUR, AQV09PSCNEUR, and AQV09PSCXEUR is their eco-friendly refrigerant. By utilizing R32 refrigerant, these models comply with environmental regulations and contribute to reduced greenhouse gas emissions. This is a significant advantage for environmentally conscious consumers looking to make sustainable choices.

In terms of user experience, these air conditioners feature a user-friendly interface and remote control functionality. This allows users to effortlessly adjust settings, program timers, and switch modes from the comfort of their seat. Additionally, many units in the series can be connected to smart home systems, providing even greater convenience through integration with mobile devices.

In conclusion, the Samsung AQV12PSCXEUR, AQV12PSCNEUR, AQV09PSCNEUR, and AQV09PSCXEUR air conditioners are packed with features designed for efficiency, comfort, and convenience. With their inverter technology, superior filtration systems, quiet operation, modern design, and eco-friendly refrigerants, they stand out as a leading choice for anyone seeking reliable cooling solutions.
Top Page Image Contents