digital device such as a digital camera, camcorder or USB memory to the USB port, but they do not work.
an additional driver installation. Check if the device you want to connect to is a device that supports the removable disk function without an additional driver installation.
The file list does | 1) | Check the files on the card. If only abnormal files (e.g. 0KByte, broken JPEG) |
not appear. | exist, the files do not appear on the screen. | |
| 2) | The time required to display is determined by the size of the file. Wait a |
| moment. | |
| 3) | Check if the format of the file is supported by the Client Monitor. If the |
| extension of the file has been changed, the file will not be played. | |
Check the following items if there is trouble with the monitor.
Check if the power cord and the video cables are properly connected to the computer.
Check if the computer beeps more than 3 times when booting.
(If it does, request an a service for the main board of the computer.)
If you installed a new video card or if you assembled the PC, check if the installed the adaptor(video) driver and the monitor driver.
Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz. (Do not exceed 75 Hz when using the maximum resolution.)
If you have problems in installing the adaptor (video) driver, boot the computer in Safe Mode, remove the Display adaptor at the "Control Panel → System → Device Administrator" and then reboot the computer to reinstall the adaptor (video) driver.
If problems repeatedly occur, contact an authorized service center.
Q & A
Question
How can I change the frequency?
How can I adjust the resolution?
How can I set the Power Saving function?
How can I clean the outer case/LCD Panel?
Answer
Frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version of the driver used.
(Refer to the computer or the video card manual for details.)
Windows XP :
Set the resolution at the Control Panel → Appearance and Themes → Display → Settings.
Windows ME/2000 :
Set the resolution at the Control Panel → Display → Settings.
Contact the video card manufacturer for details.
Windows XP :
Set the resolution at the Control Panel → Appearance and Themes → Display → Screen Saver.
Set the function at
Windows ME/2000 :
Set the resolution at the Control Panel → Display → Screen Saver.
Set the function at
Refer to Windows/Computer Manual
Disconnect the power cord and then clean the