Automatic Save, Direct-Access Features

Adjusting Your FPD

Automatic Save

Whenever you open the on-screen menu and allow an adjustment window to remain on-screen for about three seconds without pressing another button, this FPD automatically saves any adjustments you have made. These changes are saved into a user area in the FPD. User areas are reserved according to the signal frequency from your computer. This FPD can save adjustments for up to ﬁve user modes. It has ten factory preset or preload modes, one for each signal frequency as listed in the “Preset timing modes” on page 20.

If you have made no adjustments, the on-screen menu disappears and the FPD does not save anything.

Direct-Access Features

The features described on this page and the next page can be accessed quickly, at the touch of one button.

Once you ﬁnish making adjustments to a feature, push the EXIT button to turn off the menu or allow the OSM to time-out and disappear automatically.

Español Français English

Auto Adjustment

No Yes

Ð+

EXIT: Exit key

Brightness

Ð+

EXIT: Exit key

Follow these instructions to enable or disable the automatic screen adjustments for your FPD.

1	With the menu off, push the EXIT button.
	The automatic adjustment display will appear.
2	Follow the directions previously given on
	page 6.

Caution : For Auto Adjustment to function correctly, the monitor must display a full screen, colored image.

Follow these instructions to adjust the brightness of the FPD’s display.

With the menu off, push the “–” (

) or

“+” (

) button. The brightness display

will appear.

Push the “+” (

) button to increase the

brightness; push the “Ð” (

) button to

decrease the brightness.

Italiano Portuguese Deutsch