Memory Module Precautions:
When removing the module, pull on the plastic portion of the connector slots tabs only. Do not pull on the metal part of the tabs, this may damage the tabs.
8.Remove the installed module if necessary.
a.Pull the tabs on the connector slot outward slightly, until the edge of the memory module pops up.
45
o
b.Hold the memory module by the edges and pull it forward out of the compartment.
9.Align the connector on the memory module with the connector of the slot.
10.Push the memory module into the slot at a slight angle (~45o) until the connectors are fully engaged.
11.Push down on the edge of the memory module until the module snaps into place.
12.Carefully align the memory module compartment door with the compartment, insuring that the tabs ate in properly then reinstall the screw you removed in step 6.
13.Replace the keyboard by inserting the top at a ~ 45o angle and carefully pushing down at the bottom near the (2) tabs until it snaps into place.
14.Close the LCD and turn over the computer, then replace the screw you removed in step 2.
15.Turn on the computer and verify during POST to check the memory integrity.
58 Users Manual