Samsung UE46B8090XPXZG How to connect to new Ad-hoc, How to connect an existing Ad-hoc device

●If Security Key is not set: When the security setting of AP that supports WPS is NONE, you can select PBC, PIN, None Security. None Security is capable of connecting to AP directly without using WPS function.

N Process of PBC, PIN is same as above. Refer to if Security Key is already set. N Try again if connecting operation doesn’t work.

•Ad-hoc: You can connect to a mobile device without an access point through the ‘Samsung Wireless LAN Adapter’ by using a peer to peer network.

How to connect to new Ad-hoc

1.Choose Select a network, then a device list is displayed.

2.While in the device list, press the Blue button on the remote or select Ad-hoc.

N The message The existing network system may have limited functionality. Do you want to change the network connection? is displayed.

3.Input the generated Network Name(SSID) and Security Key into the device you want to connect.

How to connect an existing Ad-hoc device

1.Choose Select a network, the device list is displayed.

2.Select the device you want in the Device list.

3.If security key was applied, input the security key again.

N If network doesn’t operate normally, please check the

Network Name(SSID) and Security Key again. If the Security Key is incorrect, it may be the reason for the malfunction.

	Wireless Network Setup
Select a network			3/9
		sson
			PBC
		jee
			PIN
Search		AP_1
			None Security
Ad-hoc		Ap_2

UMove EEnter RReturn

The existing network system may have limited functionality. Do you want to change the network connection?

Yes No

Wireless Network Setup-Auto

If you want to connect AP, AP should support DHCP. Only devices which support Ad-hocmode can be connected without DHCP.

1.Set Network Type to Wireless.

2.Select Wireless Network Setup.

3.Set Internet Protocol Setup to Auto.

N The Internet Protocol is set automatically.

4.Select a network through Select a network.

5.Select Network Test to check the network connectivity.

Wireless Network Setup-Manual

1.Set Network Type to Wireless.

2.Select Wireless Network Setup.

3.Set Internet Protocol Setup to Manual.

4.Set up IP Address, Subnet Mask, Gateway and DNS Server.

N Press the number buttons on the remote control when you set the Network manually.

5.Select a network through Select a network.

6.Select Network Test to check the network connectivity.

Wireless Network Setup

Internet Protocol Setup	: Auto		▶
Network Test
Select a network	: AP1
IP Address	:
Subnet Mask	:
Gateway	:
DNS Server	:
	UMove EEnter	RReturn

Wireless Network Setup

Internet Protocol Setup	: Manual					▶
Network Test
Select a network	: AP1
IP Address	:
		0	0	0	0
Subnet Mask	:
		0	0	0	0
Gateway	:
		0	0	0	0
DNS Server	:
		0	0	0	0
	UMove		EEnter		RReturn

English - 31