Samsung DV90H8000HW/EE, DV80H8100HW/EE Connected fi rmly, Connect the end of the hose to the tap

installing your dryer

Connecting the drain hose

Do not extend the drain hose.

CAUTION - Since water may leak from the connected part, be sure to one long drain hose instead of connecting short ones. If you cannot help connecting more than one hose, be sure to seal

the connected parts with silicone sealant. (Do not use the electric insulating tape for sealing.)

The end of the drain hose can be positioned in three ways:

1.Over the edge of a wash basin: The drain hose must be placed lower than 90 cm. If the end of the drain hose needs to be placed above the ground, we recommend a height of 60 cm ~ 90 cm. To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the tap with a piece of string to prevent the drain hose from moving.

Drain hose

Hose guide

Cable Tie

90 cm

2.Assemble the drain hose and the hose guide and fi x them with the cable-tie.

3.You can drain the condensed water by connecting the accessory hose (long drain hose) to the drain-outlet directly.

Connecting the direct-hose

You can immediately drain the condensed water that comes out while drying, by connecting the drain hose to the tap.

1.Assemble the hose connector and the hose.

Since there is a danger of water leaking from the hose CAUTION connecter and accessory hose, make sure that they are

connected fi rmly.

Hose Connecter

2.Connect the end of the hose to the tap.

English - 16

DV90H8000HW-03407B-07_EN.indd Sec3:16 2016-05-30 ￿￿ 6:53:49