Samsung SID-600P manual Connecting Cables and Checking Operations

Page 12

00356A SID-600P-eng 12/10/02 12:14 PM Page 22

Connecting Cables and Checking Operations

1.First connect one end of the BNC cable to the VIDEO OUT.

2.Next, connect the other end of the BNC cable to the video input terminal of the monitor.

E

3.Then, plug in the power adapter. Use a “minus” screwdriver to connect one part of the power adapter consisting of two lines to the power input terminal of the Camera as follows. (GND: marked with a white line on the cable)

4. Decide on the type of power source you want to use and then adjust the power selection switch located at the bottom of the power adapter. Then, plug the power adapter into the power receptacle.

5. If the camera operates normally, the following screen will be displayed for 5 sec- onds before it disappears.

E

ADDR: 0

TYPE : RS485, HALF

BAUD: 38400

LENS CHECK OK!

6.When controlling an RS485, please check the following:

-Communication Speed: 4800 bps ~ 38400 bps

-Data Bit Number: 8 bits

-Stop Bit Number: 1 bit

-Parity Bit: None

22

23

Image 12
Contents SID-600P Important Safety Instructions Risk of Electric Shock do not OpenTable of Contents Chapter OverviewIntroduction Part Names and Functions Installing the Camera Usual operation modeNow, let’s install the Camera and connect cables Before Installation Checking the Contents of the PackagePrecautions for Installation and Use Installation ExamplesIt can be directly installed on ceilings These items are sold separatelyPreparing Cables Installing the Camera For installing directly on a ceilingPower Adapter Cable Video CableFor installing on a pipe For installing on a pipe coming down from the ceilingFasten the supplied Assy Screw Machine For installing on a horizontal pipe Adjust the Lens direction and assemble the Dome Cover Connecting Cables and Checking Operations Structure of the Setup Menu Setup Menu OverviewCamera Menu Organization Camera IDIris Means that there is a submenuAuto Focus Manu Manual IrisSize LevelShutter AGC/MOTIONMotion White BAL ATWSet the White BAL menu to ATW AWCPhase SyncSpecial SyncPreset ID Position SETStores the Zoom and Focus positions Motion DET ExitDescription Operating Temperature 10C ~ +50C 14F~122FApprox kg/2.2lb
Related manuals
Manual 22 pages 40.61 Kb