![](/images/new-backgrounds/1162507/162507187x1.webp)
Anynet+ (HDMI-CEC) Isn't Working
When Anynet+
The problem |
| Try this! |
|
| |
| Confirm that the device is an Anynet+ device. The Anynet+ system supports Anynet+ | |
| devices only. |
|
| Check if the power cord of the Anynet+ device is properly connected. | |
| Check the cable connections of the Anynet+ device. | |
| Go to Anynet+ | Settings System Expert Settings Anynet+ |
Anynet+ does not |
| |
work. | Check whether the TV remote control is in TV mode. | |
| Check whether the remote control is Anynet+ compatible. | |
| Anynet+ may not function when some other functions are active, including Channel | |
| Search, Smart Hub, Plug & Play, etc. |
If you have disconnected and then reconnected the HDMI cable, scan for devices again or turn your TV off and on.
| Check if the Anynet+ device is properly connected to the TV, and then select the | ||
I want to start Anynet+. | Anynet+ | Settings System Expert Settings Anynet+ | |
| |||
|
|
| |
I want to exit Anynet+. | Set Anynet+ | Settings System Expert Settings Anynet+ | |
| |||
|
| ||
|
|
| |
The message |
|
| |
"Connecting to | You cannot use the remote control when you are configuring Anynet+ or switching | ||
Anynet+ device..." | |||
to a viewing mode. Use the remote control after the TV has completed the Anynet+ | |||
or "Disconnecting | |||
configuration or has switched to a viewing mode. | |||
from Anynet+ device" | |||
|
| ||
appears on the screen. |
|
| |
|
|
| |
The Anynet+ device | You cannot use the play function when Start Setup is in progress. | ||
won't play. | |||
|
| ||
|
| ||
| Check whether the device supports Anynet+. | ||
| Check whether the HDMI cable is properly connected. | ||
| Go to Anynet+ | Settings System Expert Settings Anynet+ | |
| |||
The connected device | Scan for Anynet+ devices again. | ||
is not displayed. | Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the | ||
| |||
| device is connected to your TV with an HDMI cable. Some HDMI cables may not | ||
| support Anynet+. |
| |
| If the connection is terminated because there has been a power failure or the HDMI | ||
| cable has been disconnected, please scan for the device again. | ||
|
| ||
The TV audio is not | Connect an optical cable to the TV and the receiver. | ||
ARC enables the TV to output digital sound via the HDMI (ARC) port. | |||
being played through | |||
However, ARC is only available when the TV is connected to an audio receiver that | |||
the receiver. | |||
| supports ARC. |
|