ffWhen installing the docking station, do not leave the cord carelessly on the floor since POWERbot may get tangled by it.
ffDo not use POWERbot on black colored floors.
––The POWERbot may not be able to operate normally.
ffDo not place any objects within 0.5 m to both sides and 1 m to the front of the docking station.
ffMake sure the docking station's charging contact is not damaged or have any foreign matters on it.
ffDo not install the docking station in an area with a dark floor.
––If the floor around the docking station is dark, recharging is hindered.
ffMove any obstacles that may disturb POWERbot's movement (such as children's indoor swing or slides) before cleaning.
ffDo not use the POWERbot in a place which is narrower than the turning radius (0.5 m or less) of the POWERbot.
ffTo clean all areas of your house, open all rooms and attach the boundary markers on the places where the POWERbot may get damaged such as a front door, veranda, bathroom, and stairs for safety.
ffFor the very low areas where the POWERbot may get stuck, attach the boundary markers to prevent the POWERbot from getting in.
CAUTION In use
ffUsing POWERbot on thick carpet may damage both POWERbot and the carpet.
––The POWERbot cannot pass over carpet that is thicker than 1 cm.
ffDo not use POWERbot on tables or other high surfaces.
ffThe POWERbot may bump into chair, desk legs therefore move them away for faster and efficient cleaning.
ffWhen POWERbot is operating, do not lift it up or carry it to another area.
ffDo not hold by driving wheels of POWERbot when carrying it to another area.
ffDo not put any objects on top of POWERbot and camera since it may cause malfunction.
ffRemove any large papers or plastic bags immediately when using POWERbot since they may block the intake.
ffDo not aim the red pointer directly at people or animals.
ffDo not lie down around the POWERBOT that is running.
––Your hair may be caught in the brush, resulting in physical injury.
CAUTION Cleaning and maintenance
ff If a brush or brush cover is not assembled correctly, scratches may occur on the floor, or product malfunction may occur.
ffBefore operating the POWERbot, remove the objects which could break such as
a frame, mirror, and porcelain items so that the POWERbot works without interruption.
ffPrevent any damage to POWERbot by complying with the following
––Do not clean POWERbot by spraying water directly onto it or use benzene, thinner, acetone or alcohol to clean it.
ffDo not disassemble or repair POWERbot.
This should only be done by a certified repairman.
ffAlways keep the obstacle sensor, cliff sensor and camera clean.
––If foreign matter accumulates, sensors may malfunction.