INSTALLING THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line
1) Turn on the main water supply &
supply line.
2) Run water through the dispenser until the water runs clear (6~7 minutes). This will clean the water supply system and clear air from the lines.
3) Additional flushing may be required in some households.
ICE
WATER
4) Open the refrigerator door and check if water leaks around the water filter.
| • A |
NOTE | • Before reinstalling the water filter, remove the wine shelf. |
|
Check the amount of water supplied to the ice tray.
1) Lift up (①) and pull out (➁) the ice maker bucket in the freezer.
ICE MAKER
2)When you press the test button, the ice cube container is filled with water from the water supply tap.
Check the amount of water (see the illustration below). If the water level is too low,
the ice cubes will be small.
This is not a problem with the ice maker but of the water pressure in the pipe, and occurs frequently. When this problem occurs, contact
the dealer service center to check the amount of water supplied.
TEST BUTTON
TOO HIGH
OPTIMUM
LEVEL
TOO LOW
32