INSTALLING THE WATER DISPENSER LINE
For Exterior model
Connect to the water supply line
Connect the water pipe with coupler and tap.
-Close the main water tap.
-Connect coupler “A” to the tap.
-Every join should be protected with sealing tape.
WARRANTY INFORMATION
This water line installation is not covered by the refriger- ator or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of expensive water damage.
CAUTION
The water line must be connect-
ed to the cold water pipe. If it is connected to the hot water pipe, it may cause the puri- fier to malfunction.
COUPLER “A”
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings. | TAP |
|
Select the location where the purifier is to install. (Model with the purifier)
-Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap.
-If you wish to reassemble the water inlet and outlet sides of the purifier during purifi- er installation, see the reference illustra- tion.
LINE
OUTLET
SIDE OF | 90 degree |
PURIFIER |
|
REFERENCE
PURIFIER
WATER
COUPLER
WATER INLET SIDE
OF PURIFIER
Remove any residual matter inside the purifier. (Model with the purifier)
-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier.
-If water does not come out through the line, check whether the tap is open.
-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.
OUTLET SIDE
OF PURIFIER
PURIFIER
WATER LINE
WATER
30