Lightolier 1004ICVN B1204 Page 4, Transformer Replacement Fig. K, Install new Transformer

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

9. TRANSFORMER REPLACEMENT (Fig. K)

INSTRUCTION SHEET NO.

IS:1004ICV

B1204 Page 4 of 4

1.Make sure power is off.

2.Remove REFLECTOR TRIM from ceiling.

3.Remove SCREW and lift TRANSFORMER off bracket.

4.Remove J-BOX COVER by removing wing nut.

5.Unsplice primary leads in J-BOX.

6.Remove primary leads from J-BOX cover and clip attached to side of housing.

7.Cut secondary (red) leads 6" to 8" from TRANSFORMER and dis- card faulty transformer.

8.Install new TRANSFORMER:

(WARNING: RISK OF FIRE. Transformer contains fixture thermal protector. Replace as shown and described below. Use only replacement transformer obtained from LIGHTOLIER.)

a. Splice secondary (red) leads to socket leads.

b. Attach TRANSFORMER to BRACKET with SCREW, making sure that the side of transformer that has the wire leads is facing the housing wall (Fig.L)

c. Put primary leads through clip and bushing in the J-BOX COVER.

e. Wire primary leads to supply leads.

f.Replace J-BOX COVER.

g.Install REFLECTOR TRIM.

PRIMARY
LEADS		SECONDARY
		(RED) LEADS
	CLIP SCREW
JUNCTION BOX	ROTO CLIPS	TRANSFORMER
MAX. OF (6) #12 AWG BRANCH
		PRIMARY: 120V, 60HZ
CIRCUIT CONDUCTORS SUITABLE
		SECONDARY: 110V, 50W LOAD
FOR AT LEAST 90° C PERMITTED
IN JUNCTION BOX.

Fig. K

WIRE LEADS

APERTURE

HOLE

HOUSING

WALL

TRANSFORMER

Fig. L

®LIGHTOLIER a GENLYTE company. 631 Airport Road, Fall River, MA 02720