Samsung AQ24DWAXMID Remote control display, Using the remote control, Installing the batteries

Page 12

Remote control display

Set temperature indicator

indicator

Fan speed indicator

indicator

On/Off Timer indicator

Air swing indicator

Operating mode

indicator

Turbo indicator

Energy saving

indicator

Transmit indicator

Low battery indicator

Using the remote control

•Point the remote control towards the remote control sensor of the unit.

•The unit will beep each time a button is pressed on the remote control.

•The remote control may not operate correctly if inverter fluorescent lighting is used in close proximity of the unit.

•If other electrical products operate by the remote control, call your nearest contact center.

Installing the batteries

1. Slide cover down to	2. Install two AAA
open.	batteries.
This is located on the back	Check and match the “+”
of the remote control.	and “-” signs accordingly.
	Make sure you have
	installed the batteries
	correctly.

3.Close the cover by sliding it back to its original position.

You should hear a click sound when the cover is locked properly.

Montblanc2_UMG_29051A_IB_E.indd 13

viewing _13

2008-1-22 13:32:46

Image 12

Contents Cool Summer Offer Cost Efficient SystemLook for Everywhere Only a series modelSafety information Safety InformationSevere Warning Signs Use an exclusive power source for the air conditioner Ensure no water gets into the air conditioner Potential risk of personal injury or burn Make sure there are no obstacles under the indoor unit Contents Using Advanced Functions Viewing your air conditioner before use Checking the Indoor Unit and Digital DisplayMain parts Indoor unit digital displayPower button and Room temperature sensor Removing the Front PanelChecking the Outdoor Unit Air outlet Air intake rear sideChecking the Remote Control Remote control display Using the remote controlInstalling the batteries Slide cover down to Install two AAA Open BatteriesSelecting Operation Mode Operating basic functionTurning the AIR Conditioner on and OFF AutoCool Dry Fan Heat For AQA model Adjusting the AIR Flow Direction Vertical air flowHorizontal air flow Using advanced functions Using the Turbo FunctionTo deactivate Turbo function Setting the Timer On timerTo deactivate the On timer Setting Timer Off timerTo deactivate the Off timer Combining On timer and Off timer To deactivate the timer combinationOn timer is shorter than Off timer On timer is longer than Off timerMode Temperature changes in mode To deactivate modeWaking up from mode Cool modeUsing the Function only a Series Model Using the Energy Saving Function To deactivate the Energy saving functionUsing the Evaporator Clean Function Autoheat, Heat, Fan mode approximately 15 minutesCleaning and maintaining the air conditioner Cleaning the ExteriorCleaning the Filter Air filterDNA filter Replacing the Filter Maintaining Your AIR ConditionerDeodorizing filter Troubleshooting AppendixTechnical Specifications Operation RangesQuestions or COMMENTS? Air Conditioner