Samsung VR20H9050UW/EU manual ENGLISH-06

Page 6

Safety information

WARNING Power related

ffDo not spill any liquids on the charger.

–– There is a risk of fire or electric shock.

 

ffPlease prevent any risk of electric shock or fire.

––Do not damage the power cord.

––Do not pull the power cord too hard or touch the power plug with wet hands.

––Do not use a power source other than 100-

240 V~ and also do not use a multi outlet to supply power to number of devices at the same time. (Do not leave the cord carelessly on the floor.)

––Do not use a damaged power plug, power cord or loose power outlet.

ffClean dust or any foreign matters on the pin and contact part of the power plug.

–– There is a risk of electric shock or malfunction.

ffDo not use the charger for anything other than its intended purpose.

––There is a risk of fire or severe damage to the charger.

ffAlways keep the cliff sensor clean for your safety.

WARNING In use

ffIf any abnormal sounds, smells or smoke come from POWERbot, immediately shut off the emergency switch at the bottom of POWERbot and contact a service center.

WARNING Before use

ffDo not use POWERbot near combustible materials.

––Place near candle, desktop lamps, fireplace or near combustible materials such as gasoline, alcohol, thinners etc.

ffThe POWERbot is intended for household use therefore do not use it in an attic, basement, storage, industrial building, out of indoor space, places with moisture (such as bathroom, laundry), on the table or shelves.

––The POWERbot can be damaged or malfunction.

ffInstall the Virtual guard in front of dangerous areas (such as stairs or railings) to prevent damaging the product or getting injured.

––For your safety, always keep the cliff sensor clean.

ffBe sure POWERbot does not pass through or touch any kind of liquids.

––The POWERbot can be severely damaged and it may contaminate other areas if the wheels pass through liquid.

WARNING Cleaning and maintenance

ffWhen power cord is damaged, contact a service center to get it replaced by certified repairman.

–– There is a risk of fire or electric shock.

ffPlease check with a Samsung Electronics service center when exchanging batteries.

––Using batteries from other products can cause malfunction.

ENGLISH-06

Image 6
Contents POWERbot Contents 03 Safety information Installation Safety information Safety informationGeneral ENGLISH-05 ENGLISH-06 ENGLISH-07 Installation Power of the charger must be on at all timesInstallation note Charging 3Check the charging statusAutomatic charging Steps to take if recharging is not being executedInstalling the Virtual guard Part name of the Virtual guard Using POWERbot Turning the power on/offSelecting cleaning mode Cleaning method for each modesUsing the remote control Inserting batteriesDirection control Bottom Name of each partTop Display panelSetting the schedule Setting time/scheduleSetting the time Cancelling during setupCleaning and maintaining Cleaning the dustbinCleaning the sensors and the camera Cleaning the Power brush Cleaning the Driving wheelCleaning and maintenance ChargingUse About battery About the IrDA sensorError codes Error codesTroubleshooting Symptom ChecklistOpen Source Announcement Specifications Detail informationCountry Customer Care Center Web Site