Samsung VR20H9050UW/EU manual Charging, 3Check the charging status

Page 10

Charging

	It takes approximately 160 minutes to
	completely charge when charging for the	WARNING
	first time after purchase and can be used for	WARNING
	first time after purchase and can be used for
	approximately 60 minutes.

•Rated input voltage of this product is 100-240 V~.

Charging lamp during charging (green)

1Turn on the emergency switch on the bottom

You must turn on the emergency switch to turn on POWERbot.

2Manually charge POWERbot by placing it on the charger

Make sure charge pins of POWERbot and the charger is aligned.

3Check the charging status

“” will turn on according to charging progress and "FULL" will turn on when charging is complete.

ENGLISH-10

Image 10

Contents POWERbot Contents 03 Safety information Installation Safety information Safety informationGeneral ENGLISH-05 ENGLISH-06 ENGLISH-07 Installation Power of the charger must be on at all timesInstallation note Charging 3Check the charging statusAutomatic charging Steps to take if recharging is not being executedInstalling the Virtual guard Part name of the Virtual guard Using POWERbot Turning the power on/offSelecting cleaning mode Cleaning method for each modesUsing the remote control Inserting batteriesDirection control Bottom Name of each partTop Display panelSetting the schedule Setting time/scheduleSetting the time Cancelling during setupCleaning the dustbin Cleaning and maintainingCleaning the sensors and the camera Cleaning the Power brush Cleaning the Driving wheelCharging Cleaning and maintenanceUse About battery About the IrDA sensorError codes Error codesTroubleshooting Symptom ChecklistOpen Source Announcement Specifications Detail informationCountry Customer Care Center Web Site