Troubleshooting
Check this list of possible problems and solutions before bringing your vacuum to a service center.
Vacuum cleaner won't run.
Possible Causes
Power cord not firmly plugged in Blown fuse or breaker
Remedies
Check electrical plug Check/replace fuse - Reset breaker
Vacuum cleaner won't pick up dirt.
Possible Causes
Incorrect Height Adjustment
Hose not attached to suction opening Crack or hole in Hose
Remedies
Adjust Powerfoot to correct height setting
Grasp Quick Reach Handle and firmly push Hose Wand onto the suction opening
Check Hose and replace if needed
Vacuum cleaner won't pick up dirt continued.
Possible Causes
Broken or worn Drive Belt Rotating Floor Brush bristles worn Rotating Floor Brush jammed Clog in vacuum
Dirt Container full
Dirt Container or Upper Tank not installed properly
Filters are dirty
Remedies
Replace Drive Belt, see pg. 9 Replace brush
Remove brush and clean debris from brush ends Follow instructions on pg. 10 for clearing clogs Empty Dirt Container
Position correctly and lock in place
Check and clean Upper Tank,
Tools won't pick up dirt.
Possible Causes Crack or hole in Hose Clog in vacuum Dirt Container full
Dirt Container or Upper Tank not installed properly
Filters are dirty
Remedies
Check Hose and replace if needed
Follow instructions on pg. 10 for clearing clogs Empty Dirt Container
Position correctly and lock in place
Check and clean Upper Tank,
Vacuum cleaner is difficult to push.
Possible Causes | Remedies |
Incorrect Height Adjustment | Adjust Powerfoot to correct height setting |
|
|
Visible dirt escaping from cleaner. |
|
|
|
Possible Causes Dirt Container full
Filters missing or installed incorrectly Dirt Container installed incorrectly
Remedies
Empty Dirt Container
Check Upper Tank,
Pull out and
If suggested solutions do not correct the problem, call:
Esta aspiradora cumple las siguientes directivas de EMC: 89/336/EEC, 92/31/EEC y 93/68/EEC
Directiva sobre seguridad en aparatos de bajo voltaje: 73/23/EEC y 93/68/EEC