Samsung VCU364S13R/XFA manual Assembling Parts, Attaching the Handle, Attaching the Hose and Tools

Assembling Parts

Assembled Vacuum Cleaner Parts

The assembled cleaner will look like the illustration to the left.

Crevice Tool

Upper Tank Knob Extension Wand

Dusting Brush

Handle

Hose Clip

Stretch Hose

		Power Switch
Quick Release		Upper Tank
Cord Wrap	Louvers	Frame and
		Filter(Inside
Carrying		Louvers)
Handle	Power Cord
Quick Reach		Upper Tank
	Dirt Container	Post-Motor Filter
Handle
	Pre-Motor Filter	Hepa Media Filter
	Height	(Optional Item)
Hose Wand		Lock ’n Seal™
	Adjustment
		Lever
	Knob
		Handle
Hose	Powerfoot
		Release Pedal
Wand Base		Furniture Protection Guard

WARNING!

OPERATE THE VACUUM CLEANER ONLY AT THE VOLTAGE SPECIFIED ON THE NAMEPLATE.

1. How to put it together.

Step 1. Attaching the Handle

1-1

Locate the vacuum Handle and remove the screw packet taped to the base of the Handle.

Stand the vacuum upright and slide the base of the handle firmly into the grooves at the top of the vacuum body.

1-2

Check to be sure the Handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly until the Handle is flush.

Insert one screw provided from the screw packet into the existing hole. Tighten securely with a Philliphs head screwdriver.

Step 2. Attaching the Hose and Tools

Position the Hose 1-4Assembly on the back of the vacuum as shown.

Attach the Hose with the remaining two screws from the packet.

Grasping the Quick Reach Handle, slide the end of the Hose Wand onto the Hose Wand Base. Snap the Hose into the Hose Clip.

NOTE: The Powerfoot will not operate effectively unless the

1-5

Slide the

Extension

Wand and the Crevice Tool together into the storage clip as shown.

Tighten securely with a screwdriver.

Hose Wand is firmly attached.

Slide the Dusting Brush Tool into the storage clip as shown.

2