When to replace Agitator brush roll | Samsung VCU364S13R/XFA

	Maintenance
3-10	3-11	How to replace
		Disconnect cleaner from electrical
		outlet.
		Remove bottom plate, belt and
		agitator following directions in “The
		belt” section beginning with Fig. 3-10.
		Discard old agitator.
		Continue following the directions in
Grasp agitator firmly and fit it into	Reposition bottom plate and 4	“The belt” section to reposition belt,
position by first sliding the end opposite	screws. Tighten screws securely.	new agitator and bottom plate.
the belt into the rectangular slot (F) on		3-14
side of cleaner.		3-14
Pull other side of agitator (G) into place. 3-12		Suction Inlet
Turn agitator, making sure belt is not		Suction Inlet
Turn agitator, making sure belt is not
pinched between agitator and agitator
shield.
When to replace the
agitator brush roll
When agitator brushes are worn,		Remove the Upper Tank and check
the agitator should be replaced.		Remove the Upper Tank and check
the agitator should be replaced.	3-13	the suction inlet for a clog.
To check condition of brushes,		the suction inlet for a clog.
To check condition of brushes,

disconnect cleaner from
electrical outlet.		WARNING:
Move the edge of a card across		WARNING:
Move the edge of a card across		To reduce the risk of injury from
bottom plate while turning agitator.		To reduce the risk of injury from
To maintain cleaning effectiveness,		moving parts and/ or electrical
replace agitator if brushes do not		shock, turn Power Switch OFF and
touch card.		disconnect plug from electrical
		outlet before performing
Cleaning Clogs	Empty Dirt Container.	troubleshooting checks.
Cleaning Clogs	Empty Dirt Container.
Low suction or poor pickup may be	Check Upper Tank for build up or
Low suction or poor pickup may be	clogs.	3-16
due to a clog in the vacuum	clogs.
due to a clog in the vacuum
cleaner. If you notice a change in
the sound of the motor or a
reduction in the spinning action,
check for clogs.
3-15	Grasp the Quick Reach Handle
	and lift Hose Wand to
	separate from the suction opening.	Air Passageway
	Check for a clog in	If the clog persists, follow the
	the Base, the Wand or the Hose.	If the clog persists, follow the
	Remove the screw attaching the	instructions for Checking
	Hose Wand Base to the	the Rotating Floor Brush on page 9
	vacuum. Straighten the Hose	and inspect the Air
	Wand Base and unclog	Passageway for obstructions.
	with long, narrow object.

outlet.