Samsung ME82V-B/BOL, ME82V-WW/BOL Repair the microwave oven, Staff should be allowed to modify or

PRECAUTION TO AVOID POSSIBLE EXPOSURE TO			IMPORTANT SAFETY INSTRUCTIONS
EXCESSIVE MICROWAVE ENERGY.			Make sure that these safety precautions are obeyed at all times.
Failure to observe the following safety precautions may result in harmful			WARNING
exposure to microwave energy.
(a) Under no circumstances should any attempt be made to			Only qualified	staff should be allowed to modify or
operate the oven with the door open or to tamper with the safety					ENGLISH
			repair the microwave oven.
interlocks (door latches) or to insert anything into the safety
			containers.
interlock holes.			Do not heat liquids and other food in sealed
(b) Do NOT place any object between the oven door and front
face or allow food or cleaner residues to accumulate on sealing			For your safety, do not use high-pressure water
surfaces. Ensure that the door and door sealing surfaces are			cleaners or steam jet cleaners.
kept clean by wiping after use first with a damp cloth and then			Do not install this appliance; near heater,
with a soft dry cloth.
			inflammable	material; in a humid, oily or dusty
(c) Do NOT operate the oven if it is damaged until it has been
			location, in a location exposed to direct sunlight
repaired by a qualified		microwave service technician trained by the	and water or where gas may leak; on un level
manufacturer. It is particularly important that the oven door closes			ground.
properly and that there is no damage to the:			This appliance must be properly grounded in
(1) Door (bent)
			accordance with local and national codes.
(2) Door hinges (broken or loose)
			Remove all foreign substances such as dust or
(3) door seals and sealing surfaces
			water from the power plug terminals and contact
(d) The oven should not be adjusted or repaired by anyone other than
			points using a dry cloth on a regular basis.
a properly qualified	microwave service technician trained by the
			Do not pull or excessively bend or place heavy
manufacturer.
This product is a Group 2 Class B ISM equipment. The definition of group			objecton the power cord.
2 which contains all ISM equipment in which radio-frequency energy is			In the event of a gas leak (such as propane
intentionally generated and/or used in the form of electromagnetic radiation
			gas, LP gas, etc.), ventilate immediately without
for the treatment of material, and EDM and arc welding equipment.
			touching the power plug.
For Class B equipment is equipment suitable for use in domestic
establishments and in establishments directly connected to a low voltage			Do not touch the power plug with wet hands.
power supply network which supplies buildings used for domestic			Do not turn the appliance off by unplugging the
purposes.
			power plug while an operation is in progress.
			Do not insert fingers or foreign substances, If any
			foreign substance such as water has entered the
			appliance, unplug the power plug and contact
			your nearest service centre.
			5
ME82V_BOL-03910C_EN.indd 5				2011-02-01	12:33:58