INSTALLING OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator
-Slip the compression nut and plastic ferrule through the plastic tube.
-After inserting the sleeve, tighten the
Do not overtighten the compression nut.
NOTE
-Slip the compression ferrule and nut on copper(or plastic) tubing as shown.
Tighten the comperssion nut onto the
- Turn water on and check for any leakege.
Compression
Nut
Ferrule
Sleeve
Compression
fitting
Ferrule
Compressi on Nut
Waterline must be connected to drinkable water only
NOTE
(Case 2)
Check the water supply line
Connect the water pipe with coupler and tap.
-Close the main water tap.
-Connect coupler “A” to the tap.
-Every join should be protected with sealing tape.
WARRANTY INFORMATION
This water line installation is not covered by the
Follow these instructions carefully to minimise the risk of expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase
the right couplers fittings.
CAUTION
The water line must be
to the cold water pipe.
If it is connected to the hot water
pipe, it may cause the purifier to malfunction.
COUPLER “A”
TAP
INSTALLATION INSTRUCTIONS
29