Initial setup, Password Change | Samsung UE58J5200AKXXU guide

Initial setup

The initial setup dialogue box appears when the TV is first activated. Follow the on-screen instructions to finish the initial setup process such as selecting the menu language, scanning channels, connecting to the network, and more. During each step, either make a choice or skip the step. You can manually perform this process at a later time in the System > Setup menu.

-- If you connect any external device to HDMI1 before starting initial setup, the source of your live TV signal is set to STB. After finishing with this process, you will not be able to scan all channels and stores them in the TV’s memory.

-- If you want to connect aerial cable to your TV, select Aerial. In this case, you will be able to scan all channels and stores them in the TV’s memory.

Samsung's ‘On TV’ Recommendations Service

The On TV service recommends TV programmes based on their popularity or your personal preferences. To enjoy the On TV service, please follow the steps below. (You must have an Internet connection.)

1.Configure your TV: Select the TV source to be used for On TV.

Aerial: Freeview, Freesat, DVB-T/C/S

Set-top box: External Cable Box, External Satellite Box

2.Auto tuning channels: This step only occurs if ‘Aerial’ was selected in step 1.

3.Select a Service Provider: To select your preferred programme provider for On TV, enter your postcode and select your Freeview, Freesat or external satellite television provider from the displayed list.

4.Set-top Box Control Test: This test is to check if your TV remote is able to control your Set-top Box. This step only occurs if ‘Set-top box’ was selected in step 1.

Password Change

System > Change PIN

To alter the default setting of the TV, change the password.

Changing the TV’s password.

1.Run Change PIN and then enter the current password in the password field. The default password is “0-0-0-0”.

2.Enter a new password and then enter it again to confirm it. The password change is complete.

-- If you forgot your PIN code, press the buttons in the following sequence to reset the PIN to “0-0-0-0”:

In Standby mode: MUTE → 8 → 2 → 4 → POWER (On)

English - 19