Samsung DVD-R100E/EUR manual Press the ShowView button, Using the Menu button

Recording

Using the ShowView Feature

Before presetting your DVD Recoder:

•Switch on both the television and your DVD Recoder.

•Check that the date and time are correct.

Up to twelve programmes can be preset.

1	Press the ShowView button.
	- A message is displayed to allow you to enter the
	ShowView code.
		DVD-RAM(VR)	Programme
			Enter ShowView Code number. [0~9]

OK RETURN EXIT

Using the MENU button.

●Press the MENU button when the disc has stopped.

●Press the …† buttons to select “Programme”, and then press the OK or √ button twice.

2 Press the numeric buttons to enter the code of the programme that you wish to record in your television magazine.

●If you wish to correct the ShowView code that you are entering:

●Press the œ button until the digit to be corrected is cleared

●Enter the correct digit

3	Press the OK button.
	●	The information concerning the programme is
		displayed.
	●	When using the ShowView function for the
		first time with stored stations, the programme
		number flashes. This one time, you must enter
		the PR number manually by pressing the
		†… buttons.
			DVD-RAM(VR)						Scheduled Record List
							Remaining Recording Time 02:12 SP
				No.
								No.	01
				01							√
					Source	PR 01			Date	01 JAN

Start 12 : 00 End 14 : 00

		Type	Once			Mode	SP
		V/P
			Off
		MOVE		OK			RETURN			EXIT
DVD-RAM(VR)						Scheduled Record List
					Remaining Recording Time 02:12 SP
	No.	Source	Date		Start	End		Type	Mode	V/P Edit
	01	PR 01	01/ 01		12:00	14:00		Once	SP	Off	√
	02	-- --	--- --		--:--	--:--		--	--	--	√

MOVE OK RETURN EXIT

4 If the programme and times are correct, press the OK button.

5 Turn the power off by pressing the STANDBY/ON button to activate the Timer Recoding setting.

6 Refer to page 41~43 if you wish to:

● Check whether the timer Recording has set correctly or not.

● Cancel a preset recording

	■	The numbers next to each TV programme
		listing in the magazines or newspapers
NOTE
		are ShowView code numbers, which allow
		you to programme your
		videorecorder instantly with the remote
		control. Enter the ShowView code for the
		programme you wish to record.

■ShowView is a trademark of Gemstar Development Corporation. The ShowView system is manufactured under licence from Gemstar Development Corporation.

44- English