Troubleshooting
Troubleshooting
| Problem |
| Action |
|
|
| |
|
| • Fully open both taps. | |
|
| • Make sure the temperature selection is correct. | |
|
| • Make sure the hoses are connected to the correct taps. Flush | |
|
|
| water lines. |
|
| • Make sure the water heater is set to supply a minimum | |
|
|
| 120 °F (49 °C) hot water at the tap. Also, check the water |
|
|
| heater capacity and recovery rate. |
|
| • Disconnect the hoses and clean the mesh filter. The mesh filter | |
| Fills with the wrong |
| may be clogged. |
| water temperature. | • | While the washing machine fills, the water temperature may |
|
|
| change as the automatic temperature control feature checks |
|
|
| incoming water temperature. This is normal. |
|
| • | While the washing machine fills, you may notice just hot and/ |
|
|
| or just cold water going through the dispenser when cold or |
|
|
| warm temperatures are selected. |
|
|
| This is a normal function of the automatic temperature |
|
|
| control feature as the washing machine determines the water |
|
|
| temperature. |
|
|
| |
|
| • Use the High or Extra High spin speed. | |
| Load is wet at the | • | Use high efficiency (HE) detergent to reduce oversudsing. |
| • | Load is too small. Small loads (one or two items) may become | |
| end of a cycle. | ||
|
| unbalanced and not spin completely. | |
|
|
| |
|
| • Make sure the drain hose is not kinked or clogged. | |
|
|
| |
|
| • Make sure the door is properly closed. | |
|
| • Make sure all hose connections are tight. | |
| Leaks water. | • Make sure the end of the drain hose is correctly inserted and | |
|
| secured to the drain system. | |
|
|
| |
|
| • | Avoid overloading. |
|
| • | Use high efficiency (HE) detergent to prevent oversudsing. |
|
|
| |
|
| • Excessive suds collect in recesses and can cause foul odours. | |
| Has odours. | • Run cleansing cycles to sanitize periodically. | |
| • | Clean the door seal (diaphragm). | |
|
| ||
|
| • Dry the washing machine interior after a cycle has finished. | |
|
|
|
|
| No bubbles are seen | • | Overloading may screen bubbles. |
| (Bubbleshot models | ||
| • | Severely contaminated laundry may not generate bubbles. | |
| only). | ||
|
|
| |
|
|
|
|
54 | English |
|
|
WD90K6400OW_03745G_EN.indd 54
2016/7/27 13:47:38