Samsung VCR8825T3B/XET Charging, After aligning the charge pins of the main unit with, Charger

Page 21

Operating the cleaner

INSTALLING THE ROBOTIC VACUUM CLEANER

CHARGING

When the product is initially purchased, the battery

is fully discharged, and you must charge the robotic

Power Lamp

Charging Lamp

 

vacuum cleaner manually.

 

 

Turn on the Power Switch at the bottom of the product.

1. After aligning the charge pins of the main unit with

Power

Charging Lamp

Lamp

the charge pin of the charger station, press the main

 

 

 

unit until you hear a “Recharging power” sound from

 

 

the charger.

 

 

 

- The Charging Lamp turns green.

 

 

2. Check the charge status of the robotic vacuum

 

 

cleaner.

 

 

 

- When charging starts, the battery level indicator and

 

 

“ ” will be displayed in sequence in the display panel.

 

 

- When charging is complete, the battery level indicator and

Charging

Fully charged

“FULL” will be displayed in the display panel.

 

When the battery level display fl ashes

<Charge display>

Flash

 

 

while cleaning, the robotic vacuum

 

 

 

 

 

 

cleaner stops vacuuming and

complete

charging

 

automatically charges itself at the charger.

 

 

Charge

Charging Required

When the battery level fl ashes and “LO” is displayed while cleaning,

Flash robotic vacuum cleaner cannot be operated by the buttons on the

main unit. In this case, directly carry the robotic vacuum cleaner

to the charger to charge the battery. (This is when the battery is completely discharged.)

When the product is initially purchased, it will take about 120 minutes to fully charge the battery and will run for about 90 minutes.

NOTE When charging the battery while the battery is over-heated, the charging time can increase.

Measures to take when charging is not smooth.

When the robotic vacuum cleaner cannot be automatically charged, check the following:

-Turn the Power Switch at the bottom of the robotic vacuum cleaner off and on (Reset).

-Re-plug the power of the charger (Reset).

-Check whether there are any foreign substances on the charge connector and wipe the charge connector on the main unit and the charger with a dry cloth.

-Check whether there are objects near the charger that are strong refl ectors.

When separating the robotic vacuum cleaner from the charger, it will discharge naturally.

-Charge the robotic vacuum cleaner through the charger, if possible. (When leaving your home unattended for a long period of time due to a business trip, travelling etc., turn off the Power Switch of the robotic vacuum cleaner and unplug the power of the charger to store them.)

03 OPERATING THE CLEANER

Operating the cleaner _21

Image 21
Contents Please register your product at Robotic Vacuum CleanerSafety information Safety InformationOther Symbols Used Battery Charger Important Safety InstructionsGeneral Use only as described in this manualRobotic Vacuum Cleaner Contents Make sure to remove any dust or water from the power plug Power RelatedThis may result in fi re or electric shock Do not use multiple plugs in a single socketBefore USE Open all doors to clean all roomsRemove objects scattered on the floor before cleaning Clear the area Always keep the power cord of the charger plugged intoThis will result in critical damage to the charger Failing to do so may result in fi re or electric shockUSE This may result in damage when the unit accidentally dropsCleaning and Maintenance Power brush Product Features Delicate Cleaning of Every CornerVarious Cleaning Modes Safety Device EDGE-CLEANING Side Rotating BrushAuto Charging Doorsill CrossingAssembling the cleaner Cleaning BrushComponents Name of Each Part Charger Station Power Lamp Charging Lamp Charge Pin Vents Button Part Display PartInstalling the Robotic Vacuum Cleaner Operating the cleanerInstallation Order Turning the Power Switch on or OFFArrange the power cord along the wall Installing the ChargerCheck the charge status of the robotic vacuum Cleaner After aligning the charge pins of the main unit withCharging ChargerAbout the Battery Using the Robotic Vacuum Cleaner STARTING/STOPPING CleaningYou can run or stop all robotic vacuum functions Recharging Auto Cleaning While cleaningAbout the Resume Cleaning function Spot Cleaning MAX Cleaning Edge Cleaning While cleaning When cleaning is CompleteComplete and starts cleaning again from the beginning Cleaning mode Scheduled CleaningPlease Keep the Cleaning and Maintenance Methods in Mind Cleaning the Robotic Vacuum CleanerCleaning the Sensor Window and the Camera Maintain tools and fi lterFirst, empty the dust bin before cleaning it Cleaning the Dust BIN and the FilterWhen the noise suddenly increases Filter Install the Filter into the dust binBrush Cleaning the Power BrushVacuum tooth picks or cotton swabs Cleaning the EDGE-CLEANING Side Rotating Brush Cleaning the Driving Wheel Checklist Before SVC Calls TroubleshootingTroubleshooting for Error Codes Sensor windowCloth Mm Height Mm Length Mm Width Product specifi cationSpecifications Cleaning methodAbout 0.6 ℓ Main unit button typeMemo Memo Page Robo-Sauger Weitere Verwendete Symbole Symbole DER GEFAHREN-/WARNHINWEISESicherheitsinformationen SicherheitsinformationenWichtige Hinweise ZUR Sicherheit AllgemeinBatterieladegerät ROBO-SAUGER Inhalt Elektrische Sicherheit Andernfalls besteht die Gefahr von Stromschlägen oder BrandEntfernen Sie Schmutz und Wasser vom Netzstecker Öffnen Sie alle Türen, damit alle Zimmer gesaugt werden VOR InbetriebnahmeDer Robo-Sauger kann Kinder anfahren, sodass sie umfallen VOR DER Erstmaligen Verwendung Dies führt zu schwersten Schäden am LadegerätVerwenden Sie das Ladegerät niemals für andere Zwecke IM Einsatz Stellen Sie keine Gegenstände auf den Robo-SaugerVorsicht Andernfalls besteht die Möglichkeit von Störungen Reinigen diese Stellen bitte gelegentlich selbst Reinigung UND WartungDrücken Sie nicht mit Kraft gegen die Stoßfänger des Robo Zusammengebaut werdenWarnung Produktmerkmale Gründliche EckenreinigungVerschiedene Reinigungsmodi Seitlich Rotierende Kantenbürste AutomatikbetriebÜberquerung VON Türschwellen KollisionsschutzBenutzerhandbuch Reinigungsbürste KomponentenBezeichnungen DER Teile Netzlampe Ladelampe Ladestift Lüftungsschlitze LadestationTastenbereich AnzeigebereichZusammensetzen DES ROBO-SAUGERS Reihenfolge Beim InbetriebnahmeGerät EIN- UND Ausschalten Gebrauch des Robo-Saugers Installieren DES LadegerätsNachdem Sie den Ladekontakt am Sauger mit LadenInformationen ZUR Batterie STARTEN/STOPPEN DES Staubsaugers Verwenden DES ROBO-SAUGERSÜberprüfen Sie die Aufstellung des Ladegeräts AufladenInformationen zum Fortsetzen des Reinigens Automatisches SaugenPunktuelles Saugen Maximalsaugen Kanten Reinigung Starzeitvorwahl StartzeitvorwahlReinigen DES ROBO-SAUGERS Beachten SIE DIE REINIGUNGS- UND WartungshinweiseReinigen DES Sensorfensters UND DER Kamera Entleeren Sie vor dem Reinigen den Staubbehälter Reinigen DES Staubbehälters UND DES FiltersDie Saugleistung geht plötzlich zurück Der Lärm nimmt zu Wischen Sie den Staub vom Filter und Staubbehälter abSaugbürste reinigen Reinigen DER SaugbürsteFremdkörper aufzusaugen Reinigen DER Seitlichen Drehbürste FÜR DIE Kantenreinigung Reinigen DES Antriebsrads Fehlersuche Checkliste ZUR SelbsthilfeFehlerbehebung UND Fehlercodes Mm Höhe Mm Länge Mm Breite Technische DatenReinigung ElektrischPage Robotski sesalnik Varnostne Informacije Varnostne informacijeUporabljena Simbola ZA OPOZORILO/POZOR Drugi Uporabljeni SimboliPred Uporabo Robotskega Sesalnika Preberite VSA Navodila Pomembna Varnostna NavodilaSplošno Polnilnik BaterijeRobotski Sesalnik Kazalo To lahko povzroči požar ali električni udar NapajanjeNapajalnega vtiča odstranite morebitni prah ali Sicer lahko pride do okvare ali električnega udaraOdprite vsa vrata, da posesate vse prostore Pred UporaboBodo pozorni To lahko resno poškoduje polnilnik Odstranite morebitne predmetePoskrbite, da na polnilni postaji ni tekočine Polnilnik uporabljajte samo za polnjenje sesalnikaSesalnik lahko pade in se poškoduje MED UporaboZa hitrejše in natančnejše sesanje stole položite na mizo Na robotski sesalnik ne postavljajte predmetovČiščenje in Vzdrževanje Uporaba neoriginalnih baterij povzroči okvaro izdelka Sicer lahko pride do požara ali električnega udaraZnačilnosti izdelka Temeljito Sesanje Vseh VogalovRazlični Načini Sesanja Stranska Vrtljiva Krtača ZA Sesanje Robov Samodejno PolnjenjePrečkanje Praga Sistem Preprečevanja TrčenjSestava sesalnika Sestavni DeliČistilna krtača IME Posameznega Dela Lučka napajanja Lučka polnjenja Vtič za polnjenje Polnilnik postajaGumbi ZaslonNamestitev Robotskega Sesalnika Uporaba sesalnikaVrstni RED Namestitve Vklop ALI Izklop Stikala ZA NapajanjeNamestitev Polnilnika Preverite stanje napolnjenosti robotskega sesalnika PolnjenjeBaterija Uporaba Robotskega Sesalnika ZAGON/USTAVITEV SesanjaZagon Polnjenje Ko je sesanje Končano Samodejno SesanjeSesanje Območja Maksimalno Sesanje Sesanje Robov Sesanje PO Urniku Čiščenje Robotskega Sesalnika Upoštevajte Načine Čiščenja in VzdrževanjaČiščenje Okenca Senzorja in Kamere Čiščenje Posode ZA Prah in Filtra Pred čiščenjem posodo najprej izprazniteNamestite filter v posodo za prah Preden očistite zmogljivo krtačo, odstranite posodo Čiščenje Zmogljive KrtačeVzdrževanje nastavkov in fi ltra Čiščenje Stranske Vrtljive Krtače ZA Sesanje Robov Čiščenje Pogonskega Kolesca KAJ JE Treba PREVERITI, Preden Pokličete Serviserja Odpravljanje težavKoda Razlog Rešitev Napake Odpravljanje Težav Z Uporabo KOD NapakSpecifi kacije izdelka Mm višina Mm dolžina 355 mm širinaMm višina Mm dolžina 275 mm širina Specifikacije Klasifikacija Element PodrobnostiOpen Source Announcement Beležka Code No. DJ68-00620R REV0.0
Related manuals
Manual 200 pages 63.74 Kb Manual 40 pages 12.84 Kb Manual 120 pages 19.84 Kb