MTX Audio TXC6.1, TXC4.1, TXC5.1 owner manual Tweeter Mounting, Midrange Mounting

TWEETER MOUNTING

When positioning the tweeter for the best imaging, aim the passenger side tweeter toward where the driver’s head will be. The same process should also be completed on the driver’s side tweeter but this time you’ll aim the tweeter toward where the passenger’s head will be. Positioning the tweeters in this manner will help to set up a very solid soundstage.

SURFACE MOUNT

Surface Mounting

•Select mounting location. Mark wire hole and screw locations using the surface cup as a template.

•Drill holes for tweeter wires and mounting screws

•Using the supplied screws, attach the surface cup to surface

•Run tweeter wires through the hole and twist the tweeter into the cup

•Connect the tweeter wires to the supplied crossover

17/8"

FLUSH MOUNT

INSTALLATION KEY

17/8"

ANGLE MOUNT

Flush and Angle Mounting

•Select mounting location and mark a 1-7/8” diameter hole with supplied template

•Cut out the 1-7/8” hole (a hole saw is recommended for metal and hard plastic surfaces; an X-acto knife for any other surface)

•Place the supplied bevel headed screws through the flush/angle cup and thread into the mounting clip, but do not tighten

•Take the assembled flush/angle cup and mounting clip and place them into the 1-7/8” diameter hole, making sure the mounting clip goes completely through the hole

•Tighten the screw in the base of the flush cup until the cup is completely tight

•Split tweeter wires and run through the holes and twist the tweeter into the cup

MIDRANGE MOUNTING

To get the best possible music reproduction, it is important to isolate the sound that is produced from the rear of the speaker from the sound that is produced from the front of the speaker. To isolate the front from the back wave, make sure the speaker is mounted in a baffle or plate, so that the back of the speaker is in a sealed chamber.

WOOFER

WOOFER ADAPTER RING

STEALTH/O.E.M.	STEALTH/O.E.M.
	WITH ADAPTER RING

GRILLE	WOOFER	FLUSH	SPRING	MOUNTING ADAPTER RING
		MOUNT
			CLIPS	Use the included mounting adapter
		RING
				ring to fit the TXC6.1 & TXC6.0 6½"
				speaker in ≤ 6½" mounting locations

FLUSH

MOUNT

GRILLE	WOOFER	FLUSH	SURFACE
		MOUNT	MOUNT
		RING	RING

SURFACE

MOUNT

Mounting

•Select the mounting location (door panels, rear side panels, rear deck, etc...)

•Using the supplied templates, mark the mounting holes on the door panel or rear deck

•Drill or cut the required holes as needed

•Install the units as illustrated in the diagrams

*Note: The TXC6.1 and TXC6.0 are supplied with plastic mounting adapters. The adapters are used to convert the smaller basket sizes needed for European models to the larger domestic sizes. The plates will allow a tight and accurate fit, decreasing the need to fabricate adapters out of MDF or plastic.

For answers to further questions, please call 1-800-call-MTX

Three Way System

While the TXC sound quality is the best in the market, the addition of the TXC6.0 woofer can create an even better musical experience with more precise reproduction. The TXC6.0 has a separate cross- over, and the 2-way system can become a true 3-way system where it splits the lower frequencies between the original midrange and this additional woofer. This makes each speaker responsible for fewer frequencies and allows clearer, more accurate reproduction.

MTX002049 TXC Owners Manual.indd 4-5

4/6/054/6/05 3:30:423:30:42 PMPM