Connecting to an Antenna

When the TV is initially powered on, basic settings proceed automatically. ✎✎Preset: Connecting the mains and antenna.

VHF/UHF Antenna

Cable

TV Rear Panel

Plug & Play (Initial Setup)

When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the POWERPbutton. Plug & Play is available only when the Input source is set to TV.

✎✎To return to the previous step, press the Red button.

1Selecting a language

2Selecting Store Demo or Home Use

3Selecting a country

4Setting the Clock Mode

5Selecting an antenna

6Selecting a channel

7Enjoy your TV.

Press the ▲ or ▼ button, then press the ENTEREbutton.	POWER
Select the desired OSD (On Screen Display) language.	P
Select the desired OSD (On Screen Display) language.
Press the ◄ or ► button, then press the ENTEREbutton.

Select the Home Use mode. Store Demo mode is for retail environments.

To return the unit’s settings from Store Demo to Home Use (standard): Press the volume button on the TV. When the OSD volume is displayed, press and hold MENU for 5 sec.

Store Demo is only for shop display. If you select it, several functions are not able to use. Please select Home Use when you watch at home.

Press the ▲ or ▼ button, then press the ENTEREbutton. Select the appropriate country.

✎✎The option may differ depending on country.

Set the Clock Mode automatically or manually.

Auto: Select the time zone (depending on the country) where you are located.

Manual: Allows you to manually set the current date and time.

Press the ▲ or ▼ button, then press the ENTEREbutton.

Select the desired broadcasting signal.

Press the ▲ or ▼ button, then press the ENTEREbutton.

Select the channel source to memorise. When setting the antenna source to Cable, a step appears allowing you to assign numerical values (channel frequencies) to the channels. For more information, refer to Channel → Auto Tuning.

✎✎Press the ENTEREbutton at any time to interrupt the memorisation process.

Select the Watch TV. Press the ENTEREbutton.

If You Want to Reset This Feature...

Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0”. If you want to change the PIN number, use the Change PIN function.

You should do Plug & Play (MENU → System) again at home although you did in shop.

✎✎If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets the PIN to “0-0-0-0”: MUTE → 8 → 2 → 4 → POWER (on).

English - 6