Mitsubishi Electronics WD-73740 manual Usb, USB-P Power Only, Lan, ANT Antenna, Composite Video

101. Additional TV Features

More On TV Inputs and Outputs, continued

2. USB

•Use for a wireless network adapter to receive StreamTV internet content.

•The USB port can also serve as a standard USB 5-volt, 500-milliamp power output to power an accessory device.

3. USB-P (Power Only)

840Series. Standard USB 5-volt, 500-milliamp power output you can use to supply power to an accessory device. See page 14.

4. LAN

Use the LAN Ethernet jack for streaming internet video to the TV.

5. ANT (Antenna)

Connect your main antenna or direct cable service (without a cable box) to ANT. The ANT input can receive digital and analog over-the-air channels from a VHF/ UHF antenna or non-scrambled digital/analog cable source.

6. 3D GLASSES EMITTER

Use this jack for the special synchronization emitter sup- plied with some 3D glasses. The emitter sends out an infrared signal that synchronizes your 3D glasses with the screen display.

7. DVI/PC AUDIO INPUT

Connect a DVI device to one of the TV’s HDMI inputs and use this jack to send analog audio to the TV.

10. Y (Composite Video)

Analog standard-definition video inputs. Use the adja- cent R and L inputs if you wish to send audio to the TV speakers.

11. DIGITAL AUDIO OUTPUT

This output sends Dolby Digital or PCM digital audio to your digital A/V surround sound receiver. Incom- ing analog audio is converted by the TV to PCM digital audio. If you have a digital A/V receiver, this is the only audio connection needed between the TV and your A/V receiver.

12. AUDIO/SURROUND OUTPUT, L/R

840 Series. Provides analog audio output of the current program. Use to:

•Send audio to an analog A/V surround sound receiver or stereo system.

•Send a rear surround sound channel to an external amplifier or self-powered speakers. See page 15.

•Send audio to headphones. Set Sound > Global > Analog Audio Out to Variable.

Digital audio from digital channels and HDMI devices is converted to analog audio by the TV for output on these jacks.

13. CENTER INPUT

840 Series. Connect your A/V receiver’s center channel output to this input to have the TV speak- ers complement your external sound system with center-channel sound. Set Sound > Global > Center Channel to On to enable this input. See “Using the TV Speakers as a Center Channel,” page 16.

8. L/R (INPUT 1 audio)

Analog stereo inputs for use in conjunction with adja- cent composite or component video jacks.

9. Y Pb Pr (Component Video)

Analog video inputs able to accept high-definition video from a high-definition source device. Use the adja- cent R and L inputs if you wish to send audio to the TV speakers.

14. SUBWOOFER OUTPUT

840 Series. Connect a powered subwoofer to this input to complement effects from the TV’s speakers. Set Sound > Global > Subwoofer to On to enable this output (see “Adding a Subwoofer,” page 14).

15. EXTERNAL CONTROLLER INPUT

840 Series. Accepts control signals from an external controller when set up by your professional installer. The controller should send electronic versions of remote control IR commands.

For assistance call 1(800) 332-2119