Installation Instructions | FHP |
CABLE MANAGEMENT
WARNING: Make sure your cables do not run through a pinch point.
1.Route power/audio/video cables against column, allowing suf- ficient slack in cables for extension and avoiding pinch points.
2.Install top cable cover over cables (see Figure 5).
3.Measure distance of remaining exposed cables and, using a saw or appropriate tool, cut lower cable cover to length.
4.Install bottom cable cover over remaining exposed cables.
ADJUSTMENTS
CAUTION: Overtightening adjustment will cause excessive wear.
Rotational Tilt, Pitch, and Roll Adjustment
1.If necessary, use a Phillips screwdriver to tighten or loosen the Phillips pan head screw (see “DRAWINGS” on page 3).
2.Check for desired tension.
3. Repeat Steps 1 and 2 until desired tension is obtained. | Figure 5. Install Cable Cover |
6