•• When connecting the speaker cables to the surround speakers, follow these steps:
1.Match the speaker cable connected to the grey jack to the speaker with the grey label.
2.Match the speaker cable connected to the blue jack to the speaker with the blue label.
3.Insert the red and black coloured ends of each speaker cable into the red and black jacks of the appropriate speaker.
•• The labels are on the backs of the speakers.
2. Check the standby status after plugging into an electrical outlet
Plug the Wireless Receiver Module power cord into an electrical outlet and into the Wireless Receiver Module to turn on the Wireless Receiver Module. The LINK LED indicator (blue LED) on the Wireless Receiver Module blinks. If the LED does not blink, refer to step 8 on page 11.
POWER
L | R |
|
|
| STANDBY |
SURROUND SPEAKERS OUT | LINK | |
SPEAKER IMPEDANCE : 3Ω | ||
ID SET 
LINK 
Blue blinking
POWER
Attach the Toroidal Ferrite Core to the Power Cord of the Soundbar
(Applicable only when connecting the
AC 100V~240V
4A~1.66A
POWER
OUT
(For TV)
POWER
IN
POWER | DIGITAL AUDIO IN |
|
(OPTICAL) | HDMI IN | |
(ForOUTTV) | WIRELESS | |
POWERIN | AUX IN | HDMI OUT |
Bottom of the Soundbar
Attach the Toroidal ferrite core to the power cord of the Soundbar to help prevent RF interference from radio signals.
1.Pull the fixing tab of the Toroidal ferrite core to open it.
2.Make two loops in the Soundbar’s power cord.
3.Attach the Toroidal ferrite core to the Soundbar’s power cord as shown in the figure on the left, and then close it by pressing it until it clicks.
•• Ensure that the ferrite core is attached as close as possible to the power plug of the Soundbar.