Chief Manufacturing CM2L40 installation instructions Cable

Installation Instructions CM2L40

	6
	10
11
	8
	9
7	8
	9
	Cable
	pulley
	center
	shaft

Figure 20

7.Route cables under cable pulley and up over top of cable pulley. (See Figure 19) and (See Figure 20)

8.Route one cable from front (black) cable clamps through the #2 cable opening and straight down next to the cable pulley center shaft. (See Figure 19) and (See Figure 20)

9.Route one cable from front (black) cable clamps through the #3 cable opening and straight down next to the other side of the cable pulley center shaft. (See Figure 19) and (See Figure 20)

10.Route one cable from rear (gray) cable clamps through the #2 cable opening and straight down next to the cable pulley center shaft. (See Figure 19) and (See Figure 20)

11.Route one cable from rear (gray) cable clamps through the #3 cable opening and straight down next to the other side of the cable pulley center shaft. (See Figure 19) and (See Figure 20)

IMPORTANT ! : Ensure that cables are not twisted! Cables from front (black) of upper cable clamp (See Figure 19) must be on front of cable pulley (See Figure 20) and front of lower cable clamp (See Figure 19). Cables from rear (gray) of upper cable clamp (See Figure 19) must be on rear of cable pulley (See Figure 20) and rear of lower cable clamp (See Figure 19).

12.Continue routing cable(s) down through lower cable clamps. (See Figure 19)

13.Tighten upper cable clamp making certain cables are properly seated in clamp and are not pinched.

CAUTION: OVERTIGHTENING OF CABLE CLAMPS CAN CRUSH CABLES LEADING TO DAMAGE TO EQUIPMENT! DO NOT over tighten cable clamps.

14.Starting at upper cable clamp and working downward, remove slack from all cables and tighten lower cable clamps. (See Figure 19)

15.Slide cable guide side cover over CM2 mount lining up two holes in cable guide side cover with two holes in CM2 mount. (See Figure 21)

Cable guide

side cover

15

Figure 21

16.Secure cable guide side cover to CM2 mount using two screws (removed in Step 1). (See Figure 22)

16 x 2

Figure 22

13