Chief Manufacturing MF2 Series, PF2 Series Assembly, Assembling Base for Single Display Stand

MF1, MF2, PF1, PF2 Series Installation Instructions

ASSEMBLY

CAUTION: Attachment holes may be damaged if a power drill is used to insert button head cap screws. Screws should first be inserted and turned BY HAND with the hex key or with a handheld screwdriver BEFORE using the hex head drill bit and power drill to complete the attachment.

Assembling Base for Single Display Stand

1.Attach top base section (A) to the center post (F) using four 5/16-18 x 1-1/2" buttonhead cap screws (N) and four 5/16" flat washers (Q). (See Figure 1)

2.Gather stand base pieces B and C (2) as shown in Figure 3 and push them together until the edges meet.

(B)

(F) (Front)

(A) [labeled "FRONT"]

(Q) x 4

2

1

NOTE: To help determine front of base - distance (1) is shorter than distance (2).

1(N) x 4

(C)

Figure 3

3.Place top base section and center post assembly on top of the three base pieces with the center post front facing base pieces (C). (See Figure 4)

4.Fasten lower base pieces (B and C) to top base section and center post assembly using twelve 5/16-18 x 1/2" flat head cap screws (L). (See Figure 4)

4	(L) x 12
	(F)
	(Front)

Figure 1

NOTE: Ensure that post (F) front is placed to the front of base section (A). Check for "FRONT" on base section (A). (See Figure 1)

NOTE: Insert and tighten screws in order shown (1, 2, 3, 4) in Figure 2.

1

4

3

2

Figure 2

(B)

(C)

Figure 4

Assembling Base for Dual Display Stand

1.Follow Step 1 (and Figures 1 and 2) of Assembling Base for Single Display Stand.

2.Gather four base pieces (C) as shown in Figure 5 and push them together until the edges meet.

6