Problem |
| Action | |
|
| ||
| • Plug the power cord into a live electrical outlet. | ||
| • Check the fuse or reset the circuit breaker. | ||
| • Close the door and press the Start/Pause (Hold to Start) button | ||
|
| to start the washing machine. | |
|
| For your safety, the washing machine will not tumble or spin | |
|
| unless the door is closed. | |
| • | Before the washing machine starts to fill, it will make a series of | |
Stops. |
| clicking noises to check the door lock and does a quick drain. | |
• | There may be a pause or soak period in the cycle. Wait briefly | ||
| |||
|
| and the washing machine may start. | |
| • Make sure the mesh filter of the water supply hose at the water | ||
|
| taps are not clogged. Periodically clean the mesh filter. | |
| • | If the washing machine is not supplied with sufficient power, | |
|
| the washing machine temporarily will not drain or spin. As soon | |
|
| as the washing machine regains sufficient power, it will operate | |
|
| normally. | |
|
| ||
| • Fully open both taps. | ||
| • Make sure the temperature selection is correct. | ||
| • Make sure the hoses are connected to the correct taps. Flush | ||
|
| water lines. | |
| • Make sure the water heater is set to supply a minimum 120 °F | ||
|
| (49 °C) hot water at the tap. Also, check the water heater | |
|
| capacity and recovery rate. | |
| • Disconnect the hoses and clean the mesh filter. The mesh filter | ||
Fills with the wrong |
| may be clogged. | |
water temperature. | • | While the washing machine fills, the water temperature may | |
|
| change as the automatic temperature control feature checks | |
|
| incoming water temperature. This is normal. | |
| • | While the washing machine fills, you may notice just hot and/or | |
|
| just cold water going through the dispenser when cold or warm | |
|
| temperatures are selected. | |
|
| This is a normal function of the automatic temperature | |
|
| control feature as the washing machine determines the water | |
|
| temperature. | |
|
| ||
| • Use the High or Extra High spin speed. | ||
Load is wet at the | • | Use high efficiency (HE) detergent to reduce oversudsing. | |
• | Load is too small. Small loads (one or two items) may become | ||
end of a cycle. | |||
| unbalanced and not spin completely. | ||
|
| ||
| • Make sure the drain hose is not kinked or clogged. | ||
|
|
| |
Troubleshooting
English 61
2018/2/23 13:35:52